Abstract:The Heusler-type Fe2VAl alloy is a promising candidate for use in fabricating a thermoelectric power generation device because of its large Seebeck coefficient and high electrical conductivity. However, the high thermal conductivity of this alloy, as a thermoelectric material, degrades its power generation capacity. In this study, to reduce its thermal conductivity, the microstructure of a sintered Fe2V1.08Al0.92 alloy prepared via a powder metallurgical process was modified by adding oxide nanoparticles. Via the dispersion of Al2O3 nanoparticles, a sintered Fe2V1.08Al0.92 alloy with fine grains of approximately 200 nm in size was obtained due to the pinning effect on grain growth during sintering. The thermal conductivity was reduced from 16 to 11 W/mK. Upon La2O3 addition, the grain size of the Fe2V1.08Al0.92 alloy was reduced to approximately 100 nm and the thermal conductivity was further reduced to 10 W/mK. The difference in grain refinement could be caused by the lower stability of La2O3, which facilitated dispersion during ball milling, compared to that of Al2O3. As these microstructure refinements negatively affected the electronic properties, the thermoelectric performance of the Fe2V1.08Al0.92 alloy could not be enhanced. However, partial microstructure refinement with sparsely distributed La2O3 could slightly enhance the thermoelectric performance due to an appreciable reduction in the thermal conductivity without a considerable degradation in the electronic properties. By using these thermoelectric properties, a simple estimation of thermoelectric power generation, assuming a thermal resistance between the heat sources and thermoelectric module, was conducted. Remarkably, the results suggested that the reduction in thermal conductivity could enhance the output power density and conversion efficiency and reduce the optimal leg length. Thus, practically, controlling the balance between the electronic and thermal properties via microstructural modification is favorable in improving the practicability of the Fe2VAl alloy by enhancing the power generation capacity and reducing the sizes and masses of thermoelectric devices.

Decoupled charge and heat transport for high-performance Fe$_2$VAl composite thermoelectrics

Microstructure of a spark-plasma-sintered Fe2VAl-type Heusler alloy for thermoelectric application

Microstructures and Thermoelectric Properties of Heusler Fe 2 VAl Alloys Containing Oxide Nanoparticles

Stoichiometric and off-stoichiometric full Heusler $\mathbf {Fe_2V_{1-x}W_xAl} $ thermoelectric systems

Microstructure manipulation by laser-surface remelting of a full-Heusler compound to enhance thermoelectric properties

Half-Heusler alloys as emerging high power density thermoelectric cooling materials

Performance Advancements in P-Type TaFeSb-Based Thermoelectric Materials through Composition and Composite Optimizations

First-principles study of disordered half-Heusler alloys \textit{X}Fe$_{0.5}$Ni$_{0.5}$Sn (\textit{X} = Nb, Ta) as thermoelectric prospects

A novel valence-balanced double half-Heusler Ti2Zr2Hf2NbVFe5Ni3Sb8 alloy by high entropy engineering

Engineering the Thermoelectric Transport in Half‐Heusler Materials through a Bottom‐Up Nanostructure Synthesis

First principle studies on electronic and thermoelectric properties of Fe$_{2}$TiSn based multinary Heusler alloys

An Enormous Class of Double Half-Heusler Compounds with Low Thermal Conductivity

Predictive study of the new double Half-Heusler compounds Hf2FeNiSb2, Nb2Co2GaSb and ScNbCo2Sb2, promising candidates for thermoelectric applications

Thermoelectric Properties of FeVSb Half-Heusler Compounds by Levitation Melting and Spark Plasma Sintering

Alloyed triple half-Heuslers: a route toward high-performance thermoelectrics with intrinsically low lattice thermal conductivity

High thermoelectric performance in ZrNiSn through electron injection and boosting carrier mobility

Large Improvement of Thermoelectric Performance by Magnetism in Co‐Based Full‐Heusler Alloys

TaFeSb-Based Half-Heusler Thermoelectrics with High zT > 1 through the Alloying Effect

Improving the thermoelectric performance of double half-Heusler compounds ZrNi(In,Sb)

Unexpected p-type thermoelectric transport arising from magnetic Mn substitution in Fe2V1-xMnxAl Heusler compounds

Synergistic modulation of mobility and thermal conductivity in (Bi,Sb)2Te3 towards high thermoelectric performance