Abstract:The Heusler-type Fe2VAl alloy is a promising candidate for use in fabricating a thermoelectric power generation device because of its large Seebeck coefficient and high electrical conductivity. However, the high thermal conductivity of this alloy, as a thermoelectric material, degrades its power generation capacity. In this study, to reduce its thermal conductivity, the microstructure of a sintered Fe2V1.08Al0.92 alloy prepared via a powder metallurgical process was modified by adding oxide nanoparticles. Via the dispersion of Al2O3 nanoparticles, a sintered Fe2V1.08Al0.92 alloy with fine grains of approximately 200 nm in size was obtained due to the pinning effect on grain growth during sintering. The thermal conductivity was reduced from 16 to 11 W/mK. Upon La2O3 addition, the grain size of the Fe2V1.08Al0.92 alloy was reduced to approximately 100 nm and the thermal conductivity was further reduced to 10 W/mK. The difference in grain refinement could be caused by the lower stability of La2O3, which facilitated dispersion during ball milling, compared to that of Al2O3. As these microstructure refinements negatively affected the electronic properties, the thermoelectric performance of the Fe2V1.08Al0.92 alloy could not be enhanced. However, partial microstructure refinement with sparsely distributed La2O3 could slightly enhance the thermoelectric performance due to an appreciable reduction in the thermal conductivity without a considerable degradation in the electronic properties. By using these thermoelectric properties, a simple estimation of thermoelectric power generation, assuming a thermal resistance between the heat sources and thermoelectric module, was conducted. Remarkably, the results suggested that the reduction in thermal conductivity could enhance the output power density and conversion efficiency and reduce the optimal leg length. Thus, practically, controlling the balance between the electronic and thermal properties via microstructural modification is favorable in improving the practicability of the Fe2VAl alloy by enhancing the power generation capacity and reducing the sizes and masses of thermoelectric devices.

Stoichiometric and off-stoichiometric full Heusler $\mathbf {Fe_2V_{1-x}W_xAl} $ thermoelectric systems

On the structure and electronic properties of Fe$_2$V$_{0.8}$W$_{0.2}$Al thin films

Microstructures and Thermoelectric Properties of Heusler Fe 2 VAl Alloys Containing Oxide Nanoparticles

Decoupled charge and heat transport for high-performance Fe$_2$VAl composite thermoelectrics

Microstructure of a spark-plasma-sintered Fe2VAl-type Heusler alloy for thermoelectric application

Off-stoichiometric effect on magnetic and electron transport properties of Fe$_2$VAl$_{1.35}$ in respect to Ni$_2$VAl; Comparative study

Unexpected p-type thermoelectric transport arising from magnetic Mn substitution in Fe2V1-xMnxAl Heusler compounds

Enhancement of the Thermoelectric Performance of Half-Metallic Full-Heusler Mn2VAl Alloys Via Antisite Defect Engineering and Si Partial Substitution

Enhancement of the thermoelectric performance of half-metallic full-heusler Mn 2 VAl alloys via antisite defect engineering and Si partial substitution

First principle studies on electronic and thermoelectric properties of Fe$_{2}$TiSn based multinary Heusler alloys

Understanding the anomalous thermoelectric behaviour of Fe-V-W-Al based thin films

Design of High‐Performance Disordered Half‐Heusler Thermoelectric Materials Using 18‐electron Rule

Alloyed triple half-Heuslers: a route toward high-performance thermoelectrics with intrinsically low lattice thermal conductivity

Theoretical study of mechanical and thermodynamic properties of W–Fe alloys: Promising ultra-high temperature alloy materials

Band engineering of high performance p-type FeNbSb based half-Heusler thermoelectric materials for figure of merit zT > 1

A novel valence-balanced double half-Heusler Ti2Zr2Hf2NbVFe5Ni3Sb8 alloy by high entropy engineering

Comparison between the thermoelectric properties of new materials: The alloy of iron, vanadium, tungsten, and aluminum (Fe2V0.8W0.2Al) against an oxide such as NaCO2O4

TaFeSb-Based Half-Heusler Thermoelectrics with High zT > 1 through the Alloying Effect

First-principles study of disordered half-Heusler alloys \textit{X}Fe$_{0.5}$Ni$_{0.5}$Sn (\textit{X} = Nb, Ta) as thermoelectric prospects

Systematic investigation of structural, magneto-electronic, mechanical, thermophysical, optical and thermoelectric properties of Hf2VZ (Z = Ga, In, Tl) inverse Heusler alloy for spintronics applications

Electronic, Magnetic, and Structural Properties of CoFeVAl and CoFeV0.5Mn0.5Al