Abstract:We present a novel design of intracavity metal-aperture VCSELs toward high-speed and single-mode operations. The intracavity metal contact causes the transverse resonance which provides the modulation bandwidth enhancement. The small-signal modulation bandwidth can be double with a large mode-fi ld diameter of 10μm and single-mode operations. Introduction Vertical cavity surface emitting lasers (VCSELs) have exhibited the advantages of low cost, ease of fabrication into arrays, small footprint, waferscale testing, and low power consumption [1, 2]. Therefore, VCSELs are attracting much attention for use in data center networks. The network traffic in data centers is increasing rapidly and hence the development of high speed VCSELs is a key issue. The modulation bandwidth of VCSELs is typically less than ~ 20 GHz due to the limited intrinsic carrier-photon resonance (CPR) [3]. Therefore, many efforts have been done to push the modulation bandwidth of VCSELs further into the mm-wave band [4-14] However, there still remain difficulties in increasing the modulation bandwidth of singlemode VCSELs in comparison with multi-mode VCSELs, although single-mode VCSELs offer a longer link length of MM fibers thanks to narrower spectral widths. Also, the poor reliability has been a limiting factor for single-mode, small oxide aperture VCSELs. In this paper, we propose and demonstrate intracavity metal aperture VCSELs (MA-VCSEL) with a rectangular shaped oxide aperture. The fabrication process is exactly the same as intracavity contact VCSELs. We found that the intracavity metal contact causes the transverse resonance which provides the modulation bandwidth enhancement. We demonstrate the enhancement of the modulation bandwidth and single-mode operation thanks to the opticaltransverse coupled cavity effect. The mode-field diameter could be increased to 10 μm with stablesingle-mode operations. Device Structure Figure 1 (a) illustrates the schematic structure of the fabricated single-mode MA-VCSEL. The device is fabricated on a half-VCSEL wafer grown by MOCVD with 4 pairs of top p-type DBR. The active region includes three 850 nm quantum wells (3QWs). In order to form cavity structures, rectangular shaped mesas were formed by dryetching process and followed by wet-oxidation process. The size of an active region oxidation aperture is 9 x 10 m, as shown in Fig.1(b) which is large enough for high reliabilities. Polyamide was used for planarization and passivation. AuGe/Ni/Au was deposit d to form n-type electrodes. The p-type electrode (Au/Zn/Au) were deposited with a rectangular aperture. Finally, 8 pairs of dielectric Ta2O5/SiO2 were deposited above the surface of the mesas as a top hybrid DBR. We found that two lateral boundaries cause the transverse resonance as shown in Fig. 1(c). A key parameter is the distance d-W between two boundaries, which should be 1.5-2 μm to observe the transverse coupled cavity effect, we found.

Impact of coherent mode coupling on noise performance in elliptical aperture VCSELs for datacom

Effects of the Spatial Nonuniformity of Optical Transverse Modes on the Modulation Response of Vertical-Cavity Surface-Emitting Lasers

Effect of Chirped Dispersion and Modal Partition Noise on Multimode VCSEL Encoded With NRZ-OOK and PAM-4 Formats

Oxide-aperture-dependent output characteristics of circularly symmetric VCSEL structure

Single-channel 106.25 Gb/s PAM-4 and 64 Gb/s NRZ transmission with a 33.4-GHz 850-nm VCSEL with low-RIN characteristics

Comparison of 850 nm VCSEL oxide aperture designs

Impact of Oxide Aperture on the Static and Dynamic Performance of 850-nm VCSELs

High-speed VCSEL photonics for datacenter networks

1060nm Single-mode Metal-aperture VCSEL Array with Transverse Resonance and Low Power Consumption below 50 fJ/bit

Hexagonal Transverse Coupled Cavity VCSEL Redefining the High-Speed Lasers

Temperature and Noise Dependence of Tri-Mode VCSEL Carried 120-Gbit/s QAM-OFDM Data in Back-to-Back and OM5-MMF Links

50Gbps single mode 1060nm intracavity metal aperture VCSEL with transverse resonance

High-speed 850 nm Vertical-cavity Surface-emitting Lasers with Multilayer Oxide Aperture

30-GHz Bandwidth With Directly Current-Modulated 980-nm Oxide-Aperture VCSELs

Equivalent circuit modeling of the dynamic operation of ultra-high speed multi-mode VCSELs

The Impact of Oxide Layer Placement and Thickness on the Optical Properties of Oxide-Confined VCSEL

Low Power Consumption 1060nm Single-mode Intracavity Metal Aperture VCSEL with Transverse Resonance

High-power single mode operation of hybrid ion-implanted/selectively-oxidized VCSELs

Single-mode and High-speed Intracavity Metal Aperture VCSEL with Transverse Coupled Cavity Effect

Enhanced high-frequency modulation of single-mode 850nm VCSELs via dual transverse-cavity integration

Power Scaling And Beam Divergence Compression Of Bottom-Emitting Vertical-Cavity Surface-Emitting Lasers