Investigation of reflection-based measurements of microwave kinetic inductance detectors in the optical bands

Jie Hu,Faouzi Boussaha,Paul Nicaise,Christine Chaumont,Maria Appavou,Viet Dung Pham,Michel Piat

DOI: https://doi.org/10.1063/5.0207817

2024-06-12

Abstract:In this paper, we investigate the single photon response from the reflection of the Microwave Kinetic Inductance Detector (MKID) array. Reflection measurements are carried out using two configurations: one is measured simultaneously with the transmission, and the other is obtained with a single-ended MKID array terminated with an open load. Compared with the transmission, reflection measurements significantly reduce the readout noise of the single-ended MKID array. This is also reflected in the improvement of the median energy resolving power by around 20%-30% under pulsed photon illumination at $\lambda = 405$~nm, mainly due to an increase in the size of the resonance circle on the IQ plane. This method has the potential to be used to read out large MKID arrays.

Instrumentation and Methods for Astrophysics

What problem does this paper attempt to address?

### What problems does this paper attempt to solve?

This paper mainly explores the single - photon response in the optical band of Microwave Kinetic Inductance Detectors (MKIDs) based on reflectometry. Specifically, the paper aims to solve the following two key problems:

1. **Reduce read - out noise**: Traditional MKID read - out methods usually rely on the transmission signal \(S_{21}\), but this method may cause the strong reflection signal \(S_{11}\) to exceed the transmission signal in high - Q superconducting resonators. Therefore, the paper proposes to use the reflection signal \(S_{11}\) for read - out to reduce read - out noise, thereby improving the energy resolution of single - photon response.

2. **Improve energy resolution**: By comparing two different configurations - one is to measure both the reflection and transmission signals simultaneously, and the other is to measure only the reflection signal (single - ended MKID array), the paper shows that reflectometry significantly improves the median energy resolution (R) of the single - ended MKID array, by approximately 20 - 30%. This is mainly because reflectometry increases the size of the resonance circle in the IQ plane, thereby improving the energy resolution.

### Specific research content

- **Experimental configuration**:
- Use two configurations for reflectometry: one is to measure both the reflection \(S_{11}\) and the transmission \(S_{21}\) simultaneously, and the other is to measure only the reflection \(S_{11}\), with the MKID array terminal being an open - circuit load at this time.
- The reflection signal \(S_{11}\) is captured by placing a cryogenic circulator at the input end.

- **Measurement results**:
- Reflectometry significantly reduces the read - out noise of the single - ended MKID array, especially under 405 nm pulsed light irradiation, and the median energy resolution is improved by approximately 20 - 30%.
- Reflectometry increases the size of the resonance circle in the IQ plane, thereby improving the energy resolution.

- **Theoretical analysis**:
- The paper derives in detail the expressions of the reflection coefficient \(S_{11}\) and the transmission coefficient \(S_{21}\), and explains why reflectometry can reduce read - out noise.
- A mathematical model is proposed to describe the influence of reflectometry on energy resolution, including formulas (such as Eq. (12) and Eq. (13)) to explain how the change in the resonance circle radius affects read - out noise.

### Conclusion

The paper shows that the MKID read - out scheme based on reflectometry can significantly improve the energy resolution of single - ended MKID arrays and reduce read - out noise. This method is not only applicable to MKIDs in the optical band, but may also be applicable to MKID arrays in the millimeter - wave band.