Abstract:Background: The beam energy is one of the most significant parameters in particle therapy since it is directly correlated to the particles' penetration depth inside the patient. Nowadays, the range accuracy is guaranteed by offline routine quality control checks mainly performed with water phantoms, 2D detectors with PMMA wedges, or multi-layer ionization chambers. The latter feature low sensitivity, slow collection time, and response dependent on external parameters, which represent limiting factors for the quality controls of beams delivered with fast energy switching modalities, as foreseen in future treatments. In this context, a device based on solid-state detectors technology, able to perform a direct and absolute beam energy measurement, is proposed as a viable alternative for quality assurance measurements and beam commissioning, paving the way for online range monitoring and treatment verification. Purpose: This work follows the proof of concept of an energy monitoring system for clinical proton beams, based on Ultra Fast Silicon Detectors (featuring tenths of ps time resolution in 50 μm active thickness, and single particle detection capability) and time-of-flight techniques. An upgrade of such a system is presented here, together with the description of a dedicated self-calibration method, proving that this second prototype is able to assess the mean particles energy of a monoenergetic beam without any constraint on the beam temporal structure, neither any a priori knowledge of the beam energy for the calibration of the system. Methods: A new detector geometry, consisting of sensors segmented in strips, has been designed and implemented in order to enhance the statistics of coincident protons, thus improving the accuracy of the measured time differences. The prototype was tested on the cyclotron proton beam of the Trento Protontherapy Center (TPC). In addition, a dedicated self-calibration method, exploiting the measurement of monoenergetic beams crossing the two telescope sensors for different flight distances, was introduced to remove the systematic uncertainties independently from any external reference. Results: The novel calibration strategy was applied to the experimental data collected at TPC (Trento) and CNAO (Pavia). Deviations between measured and reference beam energies in the order of a few hundreds of keV with a maximum uncertainty of 0.5 MeV were found, in compliance with the clinically required water range accuracy of 1 mm. Conclusions: The presented version of the telescope system, minimally perturbative of the beam, relies on a few seconds of acquisition time to achieve the required clinical accuracy and therefore represents a feasible solution for beam commission, quality assurance checks, and online beam energy monitoring.

First (calibration) experiment using proton beam from FRENA at SINP

FOR A PHOTO-NEUTRON SOURCE DRIVEN BY 15 MeV ELECTRON LINAC

Calibration Of Proton Accelerator Beam Energy

Calibration method and performance of a time-of-flight detector to measure absolute beam energy in proton therapy

Photon and neutron dose evaluation at the beam test facility of the INFN - National laboratory of Frascati

High-power electron beam tests of a liquid-lithium target and characterization study of (7)Li(p,n) near-threshold neutrons for accelerator-based boron neutron capture therapy

Commissioning and first results of the Electron Beam Profiler in the Main Injector at Fermilab

LET calibration of ion microbeams and their SEE cross-section characterisation

Real-time neutron beam monitor utilizing scintillator technology for boron neutron capture therapy

Generation of neutron spectra and emission yields from proton-induced reactions on nat C and nat Li targets using CR-39 detectors

Detector Calibration Based on Secondary Protons of Back-n White Neutron Source

Fast neutron production at the LNL Tandem from the $^7$Li($^{14}$N,xn)X reaction

A beam-driven proton irradiation setup for precision radiation damage tests of silicon detectors

Study of Proton and Deuteron Pickup Reactions 2H(10Be,3He)9Li an 2H(10Be,4He)8Li with 44 A MeV 10Be Radioactive Beam at ACCULINNA-2 Fragment Separator

Proton spectroscopy for 11 B(p,α)2α fusion reaction with RCF films: calibration and unfolding procedure

Calibration and GEANT4 Simulations of the Phase II Proton Compute Tomography (pCT) Range Stack Detector

A beam intensity monitor for the Loma Linda cancer therapy proton accelerator

Beam characterization measurement of a duoplasmatron ion source for the Nanjing Proton Source

First application of a high-resolution silicon detector for proton beam Bragg peak detection in a 0.95 T magnetic field

Proton Shell Gaps in Nuclei from the First Complete Spectroscopy Study with FRIB Decay Station Initiator