Abstract:Compton cameras (CCs) allow for spatially resolved detection. The -ray origins are reconstructed by measuring the interaction positions and energy deposits in the scatter and absorber components, allowing to determine the scattering angle. Consequently, the energy resolution of the CC components plays a major role in component selection and detector design. For scintillators, the energy resolution strongly depends on the scintillation material, and also on the photosensor and signal processing electronics. For our CC prototype, built from a GAGG scintillation array (scatterer) with 1.6-mm crystal pitch and a monolithic LaBr 3:Ce block ( mm3), we investigated the energy resolution of the components in a readout configuration involving the new KETEK low-noise SiPM array series (PA33XXWL-0808) for the individual camera components and compared the performance with that of the previous generation (PA33XXWB-0808). Furthermore, we commissioned a CC prototype equipped with the new SiPM series, evaluated its energy resolution, and performed a systematic study of the imaging capabilities for -rays of 1274 keV (using a 22Na point source). For the GAGG scatterer, an energy resolution of 9.4% was measured. An improvement between 0.9% and 1.8% was achieved due to the superior balance of SiPM saturation, PDE, and noise compared with KETEK's previous SiPM array generation. For the absorber detector, a comparable energy resolution was obtained for SiPM arrays of the two generations with comparable microcell sizes (47 versus ). However, the reduced noise of the WL-SiPM arrays allowed to obtain an excellent energy resolution of 4.1% over a wider range of applied bias voltages (5.0–6.0 V) and, thus, gains. The CC prototype provided a spatial resolution below 6 mm and was capable of resolving shifts of the radiation source of 2 mm with an accuracy well below 1 mm.

Performance study of the JadePix-3 telescope from a beam test

Beam Test of a Monolithic Active Pixel Sensor for the CEPC Vertex Detector

Beam test of a 180 nm CMOS Pixel Sensor for the CEPC vertex detector

Performance of a focal plane detector for soft X-ray imaging spectroscopy based on back-illuminated sCMOS

Data Acquisition System for CEPC Vertex Detector Prototype

P‐4: Measurement and Analysis of a Novel Full‐Parallax Three Dimensional Display System

Test-beam Performance Results of the FASTPIX Sub-Nanosecond CMOS Pixel Sensor Demonstrator

Laboratory and beam-test performance study of a 55$~μ$m pitch iLGAD sensor bonded to a Timepix3 readout chip

Beam Test Studies of 3D Pixel Sensors Irradiated Non-Uniformly for the ATLAS Forward Physics Detector

Performance evaluation of the high-voltage CMOS active pixel sensor AstroPix for gamma-ray space telescopes

Characterization of the first prototype CMOS pixel sensor developed for the CEPC vertex detector

Time performance of Analog Pixel Test Structures with in-chip operational amplifier implemented in 65 nm CMOS imaging process

Beam Test Results of the US-CMS Forward Pixel Detector

Imaging effects due to pixel distortions in CdZnTe (CZT) detectors -- results from the HREXI Calibration Facility (HCF)

Burn-in Test and Thermal Performance Evaluation of Silicon Photomultipliers for the JUNO-TAO Experiment

The FE-I4 Telescope for particle tracking in testbeam experiments

Multipixel Characterization of Imaging CZT Detectors for Hard X-Ray Imaging and Spectroscopy

Performance of CMOS pixel sensor prototypes in ams H35 and aH18 technology for the ATLAS ITk upgrade

The Performance of the New KETEK Low-Noise SiPM Array Series: Characterization in a Compton Camera Study

Characterization of SiPM and development of test bench modules for the next-generation cameras for Large-Sized Telescopes for Cherenkov Telescope Array

Charged particle detection performances of CMOS pixel sensors produced in a 0.18 um process with a high resistivity epitaxial layer