Abstract:This paper deals with a systematic investigation on the synthesis of aluminium oxide starting from mono hydroxy aluminium oxide (boehmite, (AlOOH)) which in turn is synthesized from aluminium nitrate. Boehmite on heating forms γ, transitional alumina and α-alumina phases in the temperature range 400–600, 800–1050 and 1050–1100°C respectively. Calculation from XRD, using Scherer equation shows that γ-alumina has crystallite size in the range 5–10 nm, while δ and θ-alumina are in the range 10–20 nm and α-alumina is about ∼33 nm. The textural features of aqueous sol-gel boehmite samples calcined at various temperatures were analyzed by specific surface area measurements and adsorption isotherm features. Maximum specific surface area of 266 m2/g is observed for the precursor calcined at 400°C and a minimum of 5 m2/g at 1100°C. Total pore volume is maximum for the precursor calcined at 600°C (0.2653 cm3/g). Average pore size ranges from ∼3 nm (400°C) to ∼11 nm (1100°C). The adsorption isotherms also show a change from Type IV to Type II with increase in temperature showing difference in surface properties. The information from t-plots, pore size distribution and cumulative pore volume data also indicates differences in porosity features of boehmite on calcination. The adsorption isotherm and pore size distribution analysis show maximum microporosity at 400°C, while maximum mesoporosity is observed at 600°C. At higher temperatures, porosity decreases, even though small fraction of pores in the mesopore range is still retained. At 1100°C, there is structural transformation from transitional to α-alumina, with very low specific surface area ∼5 m2/g and pores in the size range of 11 nm. The various data presented in this study will be useful in the synthesis of alumina with tailor made properties.

Aluminosilicate formation in various mixtures of tetra ethyl orthosilicate (TEOS) and aluminum nitrate (ANN)

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Multinuclear solid-state NMR studies on the formation mechanism of aluminophosphate molecular sieves in ionic liquids

Synthesis and structural characterization of alumina nanoparticles

Dynamics of growth of silica particles from ammonia-catalyzed hydrolysis of tetra-ethyl-orthosilicate

Hydrolysis and Condensation of Tetraethyl Orthosilicate at the Air–Aqueous Interface: Implications for Silica Nanoparticle Formation

Gas‐Phase and Solid‐State Simultaneous Mechanism for Two‐Step Carbothermal AlON Formation

Correlation of the precursor type with densification behavior and microstructure of sintered mullite ceramics

Synthesis and properties of aluminosilicate mesoporous material with adjustable pore structure

Adsorption Isotherm and Pore Characteristics of Nano Alumina Derived from Sol-Gel Boehmite

Synthesis and Formation Mechanism of Aminated Mesoporous Silica Nanoparticles

Preparation and Crystallization of Si-Al Gel

Influence of the Nature of the Al Source on the Properties of the Initial Reaction Gels for Crystallization of Molecular Sieve AlPO4-11

Influence of Preparation Conditions on Thermal Stability of Alumina Modified by Sio2

Templating of high-silica zeolites by tetrahydrofuran in the Na2O – SiO2 – Al2O3 – H2O system

Optical Properties of One Pot Synthesized Porous, Monodisperse, Size-Controlled Silica Particles: Effect of Tetra Alkoxysilane Addition Rate

Preparation and Characterization of Mullite Whiskers from Different Silica Sources via Molten Salt Reaction

Formation kinetics of high-temperature phase sulphoaluminate

Phase Formation in Alkaline Titanosilicate Systems during Hydrothermal Synthesis

Elucidating the Role of Tetraethylammonium in the Silicate Condensation Reaction from Ab Initio Molecular Dynamics Simulations

In situ reaction mechanism of MgAlON in Al–Al2O3–MgO composites at 1700°C under flowing N2