Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Separation of fine waste catalyst particles from methanol-to-olefin quench water via swirl regenerating micro-channel separation (SRMS): A pilot-scale study

Industrial application of swirl regenerating micro-channel separation (SRMS) for fine catalysts removal from methanol-to-olefin quench water

Collaborative removal of fine catalysts particles and insoluble organics from methanol-to-olefins reaction wastewater using horizontal swirl regeneration micro-channel separation (HSRMS)

Simulation of multi-fluidized-bed in series for methanol to olefins

Cooperative physical separation of oil and suspended solids from methanol-to-olefin wastewater: A pilot study

On-site source-separation of microparticles and reuse of coal gasification wastewater via a micro-channel separator: Performance and separation mechanism

Application of Optimized Microchannel Separator to Maximize the Reuse Efficiency of Purified Water in the Petrochemical Industry

A Micro-Reactor with Micro-Pin-fin Arrays for Hydrogen Production Via Methanol Steam Reforming

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

DESIGN OF INTEGRATED PROCESS OF DISTLLIATION AND PERVAPORATION FOR THE SEPARATION OF MTBE-C4-METHANOL MIXTURE

Effective separation of water-DMSO through solvent resistant membrane distillation (SR-MD)

Structural optimization of gas-solid separator used in TMSR-SF based on computational fluid dynamics

Pilot-scale evaluation of the sustainability of membrane desalination systems for concentrate volume minimization of coal chemical wastewater

Advanced organic recovery from municipal wastewater with an enhanced magnetic separation (EMS) system: Pilot-scale verification

A new separation flowsheet for resources recovery from waste coal gasification fine slag black water and its benefits analysis

Pure water and resource recovery from municipal wastewater using high-rate activated sludge, reverse osmosis, and mainstream anammox: A pilot scale study

High efficient separation of H 2 /CH 4 using ZIF-8/glycol-water slurry: Process modelling and multi-objective optimization

FEASIBILITY OF SEMICONDUCTOR WASTEWATER RECLAMATION BY USING MBR-RO PROCESS

Effective oil-water mixture separation and photocatalytic dye decontamination through nickel-dimethylglyoxime microtubes coated superhydrophobic and superoleophilic films

Microwave Sodium Roasting (MWSR) Spent HDS Catalysts for Recovery Mo and in Situ Sulfur Fixation

Exploring the multiphase flow and mass transfer characteristics for desulfurization in an upflow biogas reactor