Multi-ellipsoid contact elastohydrodynamic lubrication performance for deep groove ball bearing

Fanming Meng,Yong Zheng,Yu Liu,Jiayu Gong,Bin Wang

DOI: https://doi.org/10.1016/j.triboint.2020.106367

IF: 5.62

2020-10-01

Tribology International

Abstract:<p>The multi-ellipsoid contact elastohydrodynamic lubrication (MECEHL) model for the deep groove ball bearing considering the forces and moments applied on the rolling elements is established and solved with optimization method. In doing so, the Newton-Raphson method is used to calculate the contact load of rolling elements, and the fast Fourier transform (FFT) is employed to accelerate the calculation of the elastic deformation. The complex method and dichotomy one are proposed to obtain the revolution velocity and rotational angular velocity of all the rolling elements. Based on the validation of the elastohydrodynamic lubrication model, the MECEHL performances for the outer-inner rings are studied and compared at the varied radial load and clearance, inner ring's rotational speed, rolling element number and initial lubricant viscosity. Through the above comparison, some rules about the MECEHL of the bearing are obtained.</p>

engineering, mechanical

What problem does this paper attempt to address?

This paper attempts to solve the problem of performance analysis of deep - groove ball bearings under the condition of multi - ellipsoidal contact elastohydrodynamic lubrication (MECEHL). Specifically, the paper establishes a multi - ellipsoidal contact elastohydrodynamic lubrication model considering the forces and moments between the ball and the inner and outer rings, and solves it by an optimization method. The Newton - Raphson method is used in the paper to calculate the contact load of the ball, and the fast Fourier transform (FFT) is adopted to accelerate the calculation of elastic deformation. In addition, the complex number method and the bisection method are proposed to obtain the rotation speed and the rotational angular speed of all rolling elements.

By verifying the validity of the elastohydrodynamic lubrication model, the MECEHL performance of the inner and outer rings under different radial loads, clearances, inner - ring rotation speeds, numbers of balls and initial lubricating oil viscosities is studied and compared. Through the above comparison, some rules regarding the MECEHL characteristics of bearings are obtained.

The main contribution of the paper is that it not only considers the lubrication behavior of single - point contact, but also considers multi - body dynamic behaviors, especially the interaction between the rolling elements and the cage as well as the inner and outer rings, which are factors not fully considered in previous studies. This makes it possible to simultaneously sense and accurately compare the lubrication performance (such as oil - film pressure, oil - film thickness, etc.) between the rolling elements and the inner and outer rings under different working conditions, thereby determining which ring may fail first.