Abstract:Heterojunction with intrinsic thin-layer (HIT) solar cells attract attention due to their high open circuit voltage and stable performance. However, short circuit current density is difficult to improve due to light losses of transparent conductive oxide and hydrogenated amorphous silicon passivation (a-Si:H) layer and low absorption coefficient of crystalline silicon (c-Si). Silicon germanium alloy (Si/Si1-xGex) quantum wells and quantum dots are capable of improving low light utilization by strong optical absorption in the infrared region. In this article, opto-MoS2of the HIT solar cells integrated with Si/Si1-xGex quantum wells (HIT-QW) as a surface absorber are investigated by numerical simulation with Technology Computer Aided Design (TCAD). The influences of germanium content on the MoS2of HIT solar cells with long carrier lifetimes of Si1-xGex layers (p*) and defect-free a-Si:H/c-Si interface are investigated at first. The simulation results indicate that optical utilization in the infrared region is enhanced with the increase of germanium fraction, while open circuit voltage degrades due to the decreasing of the energy band gap of Si1-xGex, radiative recombination and auger recombination mechanism in the Si/Si1-xGex quantum wells. And the conversion efficiency reaches a maximum value at a germanium fraction of 0.25 then drops distinctly. When the germanium fraction increases from 0 to 0.25, the short circuit current density increases from 34.3 mA/cm2 to 34.8 mA/cm2, while the open circuit voltage declines from 749 mV to 733 mV. Hence, the conversion efficiency increases from 21.5% to 21.7% due to the fact that the enhancement of short circuit current density compensates for the reduction of open circuit voltage. When the germanium content increases to more than 50%, a serious open circuit voltage loss of more than 130 mV associated with the energy band gap loss of Si1-xGex arises in the HIT-QW solar cells, which indicates that the dominating carrier transport mechanism changes from shockley diffusion to recombination in the Si/Si1-xGex quantum wells. Subsequently, the influences of interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells are discussed. Both interface holes at a-Si:H/c-Si interface and bulk holes in Si1-xGex quantum wells can be recombined through the interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells, respectively, which restricts the position of hole fermi level in the open circuit condition. When the germanium fraction increases, the influence of interface defects at a-Si:H/c-Si interface becomes weak on the degradation of open circuit voltage compared with the significant influence of the bulk trap centers. Moreover, p* of longer than 510-5 s is necessary for the retention of electrical performance of HIT-QW solar cells by the simulation. Based on this research, high-efficiency HIT solar cells can be achieved by incorporating high-quality Si/Si0.75Ge0.25 quantum wells, which also requires the impactful passivation of a-Si:H/c-Si interface.

Investigating intrinsic silicon oxide and a lightly doped p-type layer for evolution of tail states and estimating its impact as a passivation layer in a HIT type device

Surface Passivation Studies of n-type Crystalline Silicon for HIT Solar Cells

Amorphous/Crystalline Silicon Interface Stability: Correlation between Infrared Spectroscopy and Electronic Passivation Properties

Enhanced Carrier Selectivity and Superior Passivation in Cost‐Effective Heterogeneous Hybrid Transport Layers for Next Generation Silicon Solar Cells

Improved Amorphous/crystalline Silicon Interface Passivation for Silicon Heterojunction Solar Cells by Hot-Wire Atomic Hydrogen During Doped A-Si:H Deposition

The Passivation Characteristics of Poly-Si/SiOx Stack for High-Efficiency Silicon Solar Cells

Passivation properties of tunnel oxide layer in passivated contact silicon solar cells

Investigation of dual intrinsic a-Si:H films for crystalline silicon surface passivation by spectroscopic ellipsometry: application in silicon heterojunction solar cells

Long-term stability study of the passivation quality of polysilicon-based passivation layers for silicon solar cells

Interplay of annealing temperature and doping in hole selective rear contacts based on silicon-rich silicon-carbide thin films

Impact of PECVD SiON stoichiometry and post-annealing on the silicon surface passivation

Intrinsic layer modification in silicon heterojunctions: Balancing transport and surface passivation

Amorphous silicon carbide passivating layers for crystalline-silicon-based heterojunction solar cells

Oxide-nitride nanolayer stacks for enhanced passivation of p-type surfaces in silicon solar cells

Electronic Passivation of Crystalline Silicon Surfaces Using Spatial‐Atomic‐Layer‐Deposited HfO2 Films and HfO2/SiNx Stacks

Effective Passivation and Tunneling Hybrid a-SiOx(In) Layer in ITO/n-Si Heterojunction Photovoltaic Device

Numerical Simulation of Silicon Heterojunction Solar Cells with Si/Si1-xGex Quantum Wells

Effect of Surface Texture on Pinhole Formation in SiO x-Based Passivated Contacts for High-Performance Silicon Solar Cells

On the passivation mechanism of poly-silicon and thin silicon oxide on crystal silicon wafers