Abstract:Waterjet-assisted laser drilling technology facilitates the fabrication of high-quality micro-holes by utilizing the collaborative benefits of waterjets and lasers. In this study, the coaxial waterjet-assisted laser drilling (CWALD) technique was employed to improve the properties of micro-holes during femtosecond laser drilling. Based on computational fluid dynamics (CFD) simulations, the stability of the waterjet was initially verified by optimizing the structure of the watercourse and nozzle shape in the CWALD device. Furthermore, a comparative experiment between laser direct drilling (LDD) and CWALD revealed that while CWALD can produce well-rounded micro-holes with a high aspect ratio, it exhibits lower efficiency and results in a larger heat-affected zone (HAZ). To address these drawbacks associated with CWALD, a two-step coaxial waterjet-assisted composite laser drilling (TS-CWALD) method was proposed. TS-CWALD involves applying CWALD for secondary modification of micro-hole shape following LDD with punching. This modification process is pivotal for enhancing drilling accuracy but requires consideration of multiple parameters. For this purpose, regression models were established for the inlet diameter, outlet diameter, and taper; response surface methodology was then employed to optimize these parameters. Subsequently, interactive effects analysis was conducted on different responses based on laser pulse energy, frequency, modification speed, and number of modification cycles. The adequacy of the developed models was subsequently verified using analysis of variance methods. Finally, the successful fabrication of a film hole with an inlet diameter of 205 μm and an outlet diameter of 200 μm, featuring a taper of only 0.2°, was achieved ultimately through meticulous parameter optimization. Furthermore, the micro-hole retained a minimal HAZ. The optimized parameters encompassed a pulse energy of 20.6 μJ, frequency of 127 kHz, modification speed of 3 mm/s, and shape modification carried out over 335 cycles.

A real-time hole depth diagnostic based on coherent imaging with plasma amendment during femtosecondlaser hole-drilling

Efficient Depth Measurement for Live Control of Laser Drilling Process with Optical Coherence Tomography

Width and Depth Gauging of Rectangular Subsurface Defects Based on All-Optical Laser-Ultrasonic Technology

High-quality Rapid Laser Drilling of Transparent Hard Materials

Femtosecond laser drilling of film cooling holes: Quantitative analysis and real-time monitoring

Single-beam femtosecond probe for diagnosing laser plasma parameters

Width Gauging of Surface Slot Using Laser-Generated Rayleigh Waves

Hole Drilling of Silica Glass with Infrared Femtosecond Laser Pulses

Polarization-dependent, Beam Reflection-Regulated Hole Shaping Dynamics Visualized by In-Situ Imaging of Ultrafast Laser Drilling Process

Investigation on Millijoule Femtosecond Laser Spiral Drilling of Micro-Deep Holes in Thermal Barrier Coated Alloys

Direct observation of keyhole characteristics in deep penetration laser welding with a 10 kW fiber laser.

Online Plasma Diagnostics of a Laser-Produced Plasma

A vision-based method for dimensional in situ measurement of cooling holes in aero-engines during laser beam drilling process

Influence of Laser Induced Plasma on Material Removal in Micro-Drilling Underwater

Non-integral depth measurement of high-aspect-ratio multi-layer microstructures using numerical-aperture shaped beams

Experimental investigation and optimization of modification during coaxial waterjet-assisted femtosecond laser drilling

Study on laser deep-hole drilling

High Precision Laser Deep-hole Diameter Measurement Based on Dynamic Abbe′s Principle

Study on Process and Mechanism of Laser Drilling in Water and Air

Frequency-scanning Interferometry for Depth Mapping Using the Fabry–Perot Cavity As a Reference with Compensation for Nonlinear Optical Frequency Scanning

Research on hole depth in femtosecond laser deep micropore processing technology based on filament effect