Abstract:Waterjet-assisted laser drilling technology facilitates the fabrication of high-quality micro-holes by utilizing the collaborative benefits of waterjets and lasers. In this study, the coaxial waterjet-assisted laser drilling (CWALD) technique was employed to improve the properties of micro-holes during femtosecond laser drilling. Based on computational fluid dynamics (CFD) simulations, the stability of the waterjet was initially verified by optimizing the structure of the watercourse and nozzle shape in the CWALD device. Furthermore, a comparative experiment between laser direct drilling (LDD) and CWALD revealed that while CWALD can produce well-rounded micro-holes with a high aspect ratio, it exhibits lower efficiency and results in a larger heat-affected zone (HAZ). To address these drawbacks associated with CWALD, a two-step coaxial waterjet-assisted composite laser drilling (TS-CWALD) method was proposed. TS-CWALD involves applying CWALD for secondary modification of micro-hole shape following LDD with punching. This modification process is pivotal for enhancing drilling accuracy but requires consideration of multiple parameters. For this purpose, regression models were established for the inlet diameter, outlet diameter, and taper; response surface methodology was then employed to optimize these parameters. Subsequently, interactive effects analysis was conducted on different responses based on laser pulse energy, frequency, modification speed, and number of modification cycles. The adequacy of the developed models was subsequently verified using analysis of variance methods. Finally, the successful fabrication of a film hole with an inlet diameter of 205 μm and an outlet diameter of 200 μm, featuring a taper of only 0.2°, was achieved ultimately through meticulous parameter optimization. Furthermore, the micro-hole retained a minimal HAZ. The optimized parameters encompassed a pulse energy of 20.6 μJ, frequency of 127 kHz, modification speed of 3 mm/s, and shape modification carried out over 335 cycles.

A vision-based method for dimensional in situ measurement of cooling holes in aero-engines during laser beam drilling process

In situ monitoring for numerical controlled manufacturing of large conceptual prototype based on multi-view stitching fusion

A New Boresighting Method of the Aircraft Gun Using a Laser Tracker

An Experimental Study of Turbine Vane Film Cooling Using Endoscope-Based PSP Technique in a Single-Passage Wind Tunnel

Machining Precision Online Measurement of Large Span Pin Hole Using Structured Light

Femtosecond laser drilling of film cooling holes: Quantitative analysis and real-time monitoring

Mass Fabrication of Microholes in Aviation Kerosene Filters Using the Back-water-assisted Picosecond Laser Drilling Technique

A Visual Measurement Method for Deep Holes in Composite Material Aerospace Components

A comprehensive study on water jet guided laser micro hole drilling of an aerospace alloy

Axial characteristic extraction algorithm of film cooling holes based on laser point cloud

A Laser-Based On-Machine Measuring System for Profile Accuracy of Double-Headed Screw Rotor

Femtosecond laser processing of controlled tapered micro-holes based on dynamic control of relative attitude

Research on Online Measurement Method for Small Workpiece Circular Holes Based on Machine Vision

Optimization of the femtosecond laser trepan drilling strategy on IN792 for improving hole geometrical characteristics and machining efficiency

An inspection technology of inner surface of the fine hole based on machine vision

Experimental investigation and optimization of modification during coaxial waterjet-assisted femtosecond laser drilling

Tiny hole inspection of aircraft engine nacelle in 3D point cloud via robust statistical fitting

Design of a Femtosecond Laser Percussion Drilling Process for Ni-Based Superalloys Based on Machine Learning and the Genetic Algorithm

Method for Extracting Hole Parameters of Aircraft Surface Based on Linear Laser Scanning

Axial-Stereo 3D Optical Metrology of Internally Machined Parts Using High-Quality Imaging from a Scanning Laser Endoscope

Adaptive Positioning Technology of Film Cooling Holes in Hollow Turbine Blades