What problem does this paper attempt to address?

The problem that this paper attempts to solve is how to achieve a high thermoelectric power factor (PF) in iron - selenium (FeSe) thin films. Specifically, the author proposes a simplified theoretical model - the two - band model, aiming to simultaneously achieve a large Seebeck coefficient (S) and high electrical conductivity (\(L_{11}\)), thereby obtaining a high thermoelectric power factor (PF). By applying this model to the experimental data of FeSe thin films, the author shows that this material has a high PF in a wide temperature range, and its value has a strong dependence on temperature. The key points of the paper are as follows: 1. **Background and Motivation**: - With the increasing demand of society for energy harvesting technologies, the development of high - performance thermoelectric materials has become a research hotspot. - The performance of thermoelectric materials is determined by its power factor \(PF = L_{11}S^{2}\) and dimensionless figure of merit \(ZT=\frac{PF}{\lambda}T\), where \(L_{11}\) is electrical conductivity, \(S\) is the Seebeck coefficient, and \(\lambda\) is thermal conductivity. - It is very difficult to improve the performance of thermoelectric materials because \(PF\) and \(ZT\) are determined by three inter - related physical quantities. 2. **Proposed Model**: - The author proposes a two - band model to achieve a high \(PF\) by adjusting the electronic states. - In this model, the energy spacing \(\Delta\) between the two energy bands is crucial for achieving a high \(PF\). - The effects of electron - phonon scattering and impurity scattering are considered in the model. 3. **Experimental Results and Model Verification**: - The author applies the two - band model to analyze the experimental data of FeSe thin films reported by Shimizu et al. - The experimental results show that the FeSe thin films exhibit an abnormally high \(PF\) value under the action of a vertical electric field \(E_{\perp}\), especially at around 100 K, where \(PF\) reaches about 500 mW/(m·K²). - By adjusting the parameters in the model, such as the energy spacing \(\Delta\) and the chemical potential \(\mu\), the author successfully reproduces the experimental data. 4. **Discussion**: - The author explores the effects of superconducting fluctuations and exciton - related effects on the thermoelectric response of FeSe thin films and finds that these effects are not crucial for achieving a high \(PF\). - The author also points out that a similar two - band structure may exist in other nanoscale materials, such as nanowires and nanotubes, and these materials also exhibit sub - band structures due to the quantum confinement effect. 5. **Conclusion**: - Through the two - band model, the author successfully explains the high \(PF\) exhibited by FeSe thin films under the action of a vertical electric field. - This model not only helps to understand the thermoelectric properties of FeSe thin films but also provides theoretical guidance for the development of new high - performance thermoelectric materials. In conclusion, this paper solves the problem of how to achieve a high thermoelectric power factor in FeSe thin films by proposing and verifying the two - band model, and provides a theoretical basis for further research.

Two-band Model with High Thermoelectric Power Factor and Its Application to FeSe Thin Film

High Thermoelectric Performance of a Sc2Si2Te6 Monolayer at Medium Temperatures: an Ab Initio Study.

Study of Composition-Modulated Interband Transitions Characteristic and Charge Dynamics Response of High-Throughput Fese1-Xtex Combinatorial Film

High thermoelectric power factor through topological flat bands

High ZT 2D Thermoelectrics by Design: Strong Interlayer Vibration and Complete Band‐Extrema Alignment

High Thermoelectric Performance of Intrinsic Few-Layers T-Hfse2

Anomalous enhancement of thermoelectric power factor in multiple two-dimensional electron gas system

Realized High Power Factor and Thermoelectric Performance in Cu2SnSe3

Experimental identification of critical condition for drastically enhancing thermoelectric power factor of two-dimensional layered materials

Band structure engineering of multiple band degeneracy for enhanced thermoelectric power factors in MTe and MSe (M = Pb, Sn, Ge)

Excess conductivity and Berezinskii-Kosterlitz-Thouless transition in superconducting FeSe thin films

Design of thermoelectric materials with high electrical conductivity, high Seebeck coefficient, and low thermal conductivity

Achieving ultra-high power factor in Sb2Te2Se via valence band convergence

Enhanced thermoelectric performance of Cu2Se thin film derived from potential barrier scattering by incorporating SnSe nano-dispersions

Possible High Thermoelectric Power in Semiconducting Carbon Nanotubes ~A Case Study of Doped One-Dimensional Semiconductors~

Enhanced figure of merit for famatinite Cu3SbSe4 via band structure tuning and hierarchical architecture

Thermoelectric Figure of Merit of a Superatomic Crystal Re6Se8I2 Monolayer

Multiband Effect and Possible Dirac Fermions in Fe$_{1+y}$Te$_{0.6}$Se$_{0.4}$

Exotic Superconducting States in FeSe-based Materials

Thermoelectric performance of Te composited with FeTe2 and co-doped with Sb and Se

Observation of Large Anomalous Nernst Effect in 2D Layered Materials Fe3GeTe2