Abstract:Thermoelectric (TE) materials, or materials that can generate an electrical energy from temperature gradient, are promising for renewable energy technology. One fundamental aspect in the TE research is the demand to maximize the TE power-factor, PF2=Sσ, by having as large Seebeck coefficient (S) and electrical conductivity (σ) as possible. In the early 90s, Hicks and Dresselhaus proposed the PF enhancement by using low-dimensional materials, in which electrons are confined in certain directions and they move freely in the other directions. This quantum effect is known as the confinement length (L) effect, in which L is the thickness or diameter of the two-dimensional (2D) or one-dimensional materials, respectively. However, a key challenge is to understand the critical value of L, at which the PF can be significantly enhanced. Recently, we reevaluated the confinement theory of the lowdimensional materials to solve this issue. We showed that electrons are fully confined only when L is smaller than an intrinsic length Λ, the so-called thermal de Broglie wavelength, which depends on the materials and can be experimentally measured. Monolayer 2D materials naturally satisfy the condition of L < Λ since their confinement length is ~ 1 nm, while their thermal de Broglie wavelength is ~ 5–10 nm. Therefore, they could be a good candidate for TE materials. In this review article, we first review the TE materials with low dimensions. Then, we show the basic concept of the confinement effect and the consequence of such an effect. Finally, based on this effect, we turn our attention to the progress achieved recently in the TE properties of the 2D materials such as monolayer InSe, GaN electron gas, and SrTiO3 superlattices.

Anomalous enhancement of thermoelectric power factor in multiple two-dimensional electron gas system

Experimental identification of critical condition for drastically enhancing thermoelectric power factor of two-dimensional layered materials

Quantum confinement and energy filtering effect enhancing the thermoelectric power factor of InGaAs with buried ErAs nanoparticles

High Thermoelectric Power Factor in Two-Dimensional Crystals Ofmos2

High thermoelectric power factor through topological flat bands

Multiple conduction bands with strong valley anisotropy yielding ultrahigh thermoelectric power factors in n-type elemental Ge

Large Thermoelectric Power Factor from Crystal Symmetry-Protected Non-Bonding Orbital in Half-Heuslers

Unconventional Doping Effect Leads to Ultrahigh Average Thermoelectric Power Factor in Cu 3 SbSe 4 ‐Based Composites

Quantum effects in the thermoelectric power factor of low-dimensional semiconductors

Confinement Effect in Thermoelectric Properties of Two–Dimensional Materials

High Thermoelectric Powerfactor in 2D Crystals of MoS 2

High Thermoelectric Powerfactor in Single and Few-Layer MoS_2

Bipolar conduction asymmetries lead to ultra-high thermoelectric power factor

Two-band Model with High Thermoelectric Power Factor and Its Application to FeSe Thin Film

High Thermoelectric Powerfactor in Single and Few-Layer MoS$_2$

Large transverse thermoelectric effect induced by the mixed-dimensionality of Fermi surfaces

Enhancing efficiency and power of quantum-dots resonant tunneling thermoelectrics in three-terminal geometry by cooperative effects

Understanding of Isoelectronic Alloying Induced Energy Gap Variation for a Large Enhancement of Thermoelectric Power Factor

Quantized Thermoelectric Hall Effect Induces Giant Power Factor in a Topological Semimetal

Anomalous Enhancement of Thermoelectric Performance in GeTe with Specific Interaxial Angle and Atomic Displacement Synergy

Kondo Impurities in Two Dimensional MoS2 for Achieving Ultrahigh Thermoelectric Powerfactor