Abstract:The present work investigates the effect of vanadium (V) micro-alloying addition on the microstructural evolution and mechanical properties of Al 354.0 alloy in as-cast and T6 condition. In particular, Al 354.0 with and without 0.3 wt.% V was developed by squeeze casting technique. The as-cast ingots were subjected to two types of heat treatment schedules, i.e., solution heat treatment at 495 °C for 8 h, followed by rapid water quenching and artificial aging at 190 °C for 2 h (T6), and solution heat treatment at 515 °C for 10 h, followed by rapid water quenching and artificial aging at 210 °C for 6 h (MT6), to modify the microstructure, morphology, and distribution of Al-, Cu-, and Mg-containing secondary phase(s). The phase and microstructure of unmodified and 0.3 wt.% V-modified alloys were analyzed using x-ray diffraction, optical microscopy, and field emission scanning electron microscopy coupled with energy-dispersive x-ray spectroscopy. Detailed analyses show that Al 2 Cu/Al 2 Cu(SiMg), Al 5 Si 2 Mg, and Al 2 Si were the strengthening phases in the unmodified alloy, whereas 0.3 wt.% V-modified alloy contains Al 10 V/Al 10 V(Mg), Al 3 Cu, Mg 2 Si, Al 4 Si, and Al(SiCuMg) as the primary strengthening phase(s). A subtle increase in the mechanical properties was evident in the 0.3 wt.% V-modified alloy compared to unmodified alloy at ambient temperature due to the presence of Al 10 V/Al 10 V(Mg) fine precipitates and Al(SiCuMg) intermetallic along the grain boundaries (GBs) preventing dislocation movement. T6 treatment resulted in a grain growth where needle/plate morphology of eutectic silicon was partially converted into spheroidal morphology, and Al 2 Cu/AlSiCuMg, Mg 2 Si, and Al 10 V/Al 10 V(Mg) intermetallic phases emerged increasing the tensile (0.3% V modified vs. unmodified; YS: ~ 287 vs. ~ 268 MPa, UTS: ~ 330 vs. ~ 334 MPa, elongation: ~ 1.5% vs. ~ 2.6%), compression (0.3% V modified vs. unmodified YS: ~ 497 vs. ~ 460 MPa, UCS: ~ 790 vs. ~ 776 MPa, compressive strain: ~ 40% vs. ~ 42%), and wear properties. However, modified T6 treatment (MT6) resulted in a grain growth where needle/plate morphology of eutectic silicon converted into spheroidal morphology, and Al 2 Cu partially and Mg 2 Si precipitates along the GBs were completely dissolved in the α -Al matrix by incipient melting improving the ductility (~5.9%) at the expense of yield strength (~104 MPa) and ultimate tensile strength (~218 MPa).

Structural and Magnetic Properties of V-Ti-Si Alloy Superconductors

Effect of Co Addition on the Phase Structure and Magnetic Properties of Fe-Si-Al Alloys

Ambient Temperature Growth and Superconducting Properties of Ti-V Alloy Thin Films

Superconductivity in the cobalt-doped V3Si A15 intermetallic compound

In-situ Investigation of the Phase Formation and Superconductivity in V$_3$Si Thin Films at High Temperatures

Superconductivity in V$_{1-x}$Zr$_x$ alloys]{Evolution of high field superconductivity and high critical current density in the as-cast V$_{1-x}$Zr$_x$ alloys

Structural and magnetic properties of Fe73.5Cu1Nb3−xTixSi13.5B9 (x≤3) alloys

Martensitic transformation in V3Si single crystal: 51V NMR evidence for coexistence of cubic and tetragonal phases

Structure and Magnetic Behaviours of Melt-Spun Ti1.4v0.6ni Alloy Containing Icosahedral Quasicrystalline Phase

Influence of Substrate-Induced Thermal Stress on the Superconducting Properties of V3Si Thin Films

The influences of vanadium addition and temperature on the microstructure, and mechanical properties of Al 0.1 CoCrFeNiV x multi-principal element alloys

Phase Structures and Hydrogen Storage Properties of TiV1.35Cr1.35-xMnx Alloys(x=0～0.45)

Structure, Morphology, Heat Capacity, and Electrical Transport Properties of Ti3(Al,Si)C2 Materials

Phase formation and magnetic properties of annealed mechanical alloying Nd-Fe-V-Ti alloys and their nitrides

Effect of Vanadium Addition On Structure And Soft Magnetic Properties of Nanocrystalline FeCoZrBCu Melt Spun Alloys

Structural and magnetic properties of MnCo1-xFexSi alloys

Effect of TiB2 and Al3Ti on the microstructure, mechanical properties and fracture behaviour of near eutectic Al-12.6Si alloy

Magnetic correlations and Griffith-like phase in Co$_2$TiSi$_{0.5}$Al$_{0.5}$ Heusler alloy

Effect of Vanadium Micro-alloying on the Microstructure and Mechanical Properties of Stir Cast Al 354.0 Alloy

Enhancement of irreversibility field and critical current density of rare earth containing V 0.60 Ti 0.40 alloy superconductor by cold-working and annealing

Electrons and phonons in the ternary alloy CaAl$_{2-x}$Si$_x$} as a function of composition