Abstract:The use of multiple synchronized outputs from an arbitrary waveform generator (AWG) provides the opportunity to perform EPR experiments differently than by conventional EPR. We report a method for reconstructing the quadrature EPR spectrum from periodic signals that are generated with sinusoidal magnetic field modulation such as continuous wave (CW), multiharmonic, or rapid scan experiments. The signal is down-converted to an intermediate frequency (IF) that is less than the field scan or field modulation frequency and then digitized in a single channel. This method permits use of a high-pass analog filter before digitization to remove the strong non-EPR signal at the IF, that might otherwise overwhelm the digitizer. The IF is the difference between two synchronized X-band outputs from a Tektronix AWG 70002A, one of which is for excitation and the other is the reference for down-conversion. To permit signal averaging, timing was selected to give an exact integer number of full cycles for each frequency. In the experiments reported here the IF was 5kHz and the scan frequency was 40kHz. To produce sinusoidal rapid scans with a scan frequency eight times IF, a third synchronized output generated a square wave that was converted to a sine wave. The timing of the data acquisition with a Bruker SpecJet II was synchronized by an external clock signal from the AWG. The baseband quadrature signal in the frequency domain was reconstructed. This approach has the advantages that (i) the non-EPR response at the carrier frequency is eliminated, (ii) both real and imaginary EPR signals are reconstructed from a single physical channel to produce an ideal quadrature signal, and (iii) signal bandwidth does not increase relative to baseband detection. Spectra were obtained by deconvolution of the reconstructed signals for solid BDPA (1,3-bisdiphenylene-2-phenylallyl) in air, 0.2mM trityl OX63 in water, 15N perdeuterated tempone, and a nitroxide with a 0.5G partially-resolved proton hyperfine splitting.

Order-of-Magnitude SNR Improvement for High-Field EPR Spectrometers via 3D-Printed Quasioptical Sample Holders

A Broadband NMR Magnetometer System with Field Searching and Automatic Tuning Function

Phase-Incremented Steady-State Free Precession As an Alternate Route to High-Resolution NMR.

Sample Holders for Sub-THz Electron Spin Resonance Spectroscopy

Field-domain rapid-scan EPR at 240GHz for studies of protein functional dynamics at room temperature

Frequency multiplexing enables parallel multi-sample EPR

A complete 3D-printed tool kit for Solid-State NMR sample and rotor handling

High-frequency high-power DNP/EPR spectrometer operating at 7 T magnetic field

Cryogenic W-band Electron Spin Resonance Probehead with an Integral Cryogenic Low Noise Amplifier

Dispersion EPR: Considerations for Low-Frequency Experiments

Digitally generated excitation and near-baseband quadrature detection of rapid scan EPR signals

A pH-enhanced resolution in benchtop NMR spectroscopy

Design and Performance of a New Multifunction X-band EPR Spectrometer

Boosting 1H and 13C NMR signals by orders of magnitude on a bench

Rapid scan EPR: Automated digital resonator control for low-latency data acquisition

High-field pulsed EPR spectroscopy under magic angle spinning

Enhancement of the Signal-to-Noise Ratio of an Atomic Magnetometer by 10 Db

Low-Cost Purpose-Built Ultra-Low-Field NMR Spectrometer

Design and Implementation of Integrated Dual-Mode Pulse and Continuous-Wave Electron Paramagnetic Resonance Spectrometers

A Cryogenic Tune and Match Circuit for Magnetic Resonance Microscopy at 15.2T

On the geometry optimization of X-band resonator for electron paramagnetic resonance application