Large Eddy Simulations of Fully-Developed Turbulent Flows Over Additively Manufactured Rough Surfaces

Himani Garg,Lei Wang,Guillaume Sahut,Christer Fureby

DOI: https://doi.org/10.1063/5.0143863

2023-02-02

Abstract:In the last decade, progresses in additive manufacturing (AM) have paved the way for optimized heat exchangers, whose disruptive design will depend on predictive numerical simulations. Typical AM rough surfaces show limited resemblance to the artificially constructed rough surfaces that have been the basis of most prior fundamental research on turbulent flow over rough walls. Therefore, a high-fidelity LES database is built to develop and assess novel wall models for AM. This article investigates the flow in rough pipes built from the surfaces created using AM techniques at Siemens based on Nickel Alloy IN939 material. We developed a code to generate the desired rough pipes from scanned planar surfaces and performed high-fidelity LES of turbulent rough pipe flows at Re = 11,700 to reveal the influence of roughness on turbulence, mainly the average roughness height and the Effective Slope. The equivalent sand-grain roughnesses, ks, of the present AM rough surfaces are predicted using the Colebrook correlation. In the present study, the existence of a logarithmic layer is marked even for high values of ks. The mean flow, the velocity fluctuations, and the Reynolds stresses show turbulence's strong dependence on the roughness topography. Profiles of turbulence statistics are compared by introducing an effective wall-normal distance. The effective distance collapses the shear stresses and the velocity fluctuations outside the roughness sublayer; thus, Townsend's similarity of the streamwise mean velocity is marked for the present roughnesses. Furthermore, a mixed scaling is introduced to improve the collapse of turbulence statistics in the roughness sublayer.

Fluid Dynamics

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to study the influence of rough surfaces produced by additive manufacturing (AM) technology in fully - developed turbulence through high - fidelity large - eddy simulation (LES). Specifically, the paper focuses on the following aspects:

1. **Influence of surface roughness on turbulence**: The paper explores how the rough surfaces produced by AM affect the turbulence characteristics in the pipeline, especially the influence of the average roughness height and the effective slope on turbulence.

2. **Development and evaluation of wall models**: Current wall models for steady - state and unsteady - state three - dimensional Navier - Stokes simulations do not consider the characteristics of AM rough surfaces. Therefore, the paper aims to establish a high - fidelity LES database to develop and evaluate new wall models suitable for AM rough surfaces.

3. **Prediction of friction coefficients**: The paper studies the influence of surface roughness on friction coefficients and explores how to predict the friction coefficients of these rough surfaces. Specifically, the paper uses the Colebrook correlation to predict the equivalent sand - grain roughness (\(k_s\)), and analyzes the main contributors to the friction coefficient, namely turbulence and drag.

4. **Existence of the logarithmic layer**: The paper explores whether there is a logarithmic layer at high \(k_s\) values, and analyzes the dependence of the average flow velocity, velocity fluctuations, and Reynolds stress on the roughness topology.

5. **Comparison of turbulence statistics**: By introducing the effective wall - normal distance defined by the zero - plane displacement, the paper compares the turbulence statistics of different rough surfaces and verifies Townsend's similarity hypothesis.

6. **Introduction of a mixed - scaling method**: In order to improve the collapse of turbulence statistics in the rough sub - layer, the paper introduces a mixed - scaling method.

7. **Quadrant analysis and turbulence anisotropy**: The paper also attempts to study the influence of surface roughness on fluid mechanics through quadrant analysis and turbulence anisotropy.

Overall, the paper aims to study the fluid - mechanical characteristics of AM rough surfaces through high - fidelity LES, thereby providing theoretical support for optimizing heat exchanger design.