Abstract:In this study, a broadband linearizer design method based on an extended design space is proposed to optimize the design complexity and linearization performance of conventional linearizers for broadband operation. The gain characteristics of the power amplifier (PA) and linearizer are fitted to simplify the analyses and to quickly derive the ideal objective function of the linearizer design. Then, the 1 dB compression point of a nonlinear system is redefined and used to further extend the design space of the linearizer. To verify the proposed design method, a millimeter-wave linearizer prototype based on the extended design space was designed and fabricated. The linearizer was tested with continuous-wave and 100 MHz two-tone signals from 40 GHz to 43 GHz. The measurement results of the linearized PA showed that the output 1 dB power point (OP1dB) was improved by more than 1.7 dB, the phase error was reduced by more than 15°, and the third-order intermodulation distortion (IMD3) was suppressed by 8.6 dB–13.1 dB over the working frequencies. The proposed linearizer achieved good linearization performance, low power consumption, and simple design implementation, and it was not necessary to tune the bias during broadband operation, making it applicable in complex communication scenarios.

A Design Technique for Realizing a Microwave Tunnel-Diode Amplifier in Stripline

Design and Optimization of a Milli-Meter Wave Amplifier Using Nano-Scale CMOS Devices

The Logarithmic Tunnel Diode Amplifier

D-band Neutralized Amplifier Design Based on Accurate Millimeter-Wave De-Embedding Method

U.H.F. tunnel-diode amplifier

Broadband Doherty Power Amplifier Via Real Frequency Technique

Modeling Investigation of an Ultrawideband Terahertz Sheet Beam Traveling-Wave Tube Amplifier Circuit

Theoretical Analysis and Experimental Validation of Enhancing Doherty Amplifier Gain Via Asymmetrical Input Power Splitting

A Staggered Double Vane Circuit for A W-Band Traveling-Wave Tube Amplifier

Design of a Pseudoperiodic Slow Wave Structure for a 6-kW-Level Broadband Helix Traveling-Wave Tube Amplifier

A S-band 50MW microwave amplifier's design

A Novel Scheme for Gain and Power Enhancement of THz TWTs by Extended Interaction Cavities

The design and realization of a highly linear power amplifier module for a WiMAX/WiBro (802.16e) base station

Design of a Tri-Band Doherty Amplifier Based on Generalized Impedance Inverter.

A broadband CMOS amplifier in D band using pole-tuning technique with T-type network

Design Of A Compact And High Performance 263 Ghz Sb-Twt Circuit

Design of Broadband Doherty Power Amplifier Based on Single Loop Load Modulation Network

Design of a Millimeter-Wave Broadband Linearizer Based on an Extended Design Space

Realization of directional amplification in a microwave optomechanical device

Design of A Microwave Frequency Tripler with Conversion Gain

Automated design of a linear microwave monolithic distributed amplifier