Abstract:Decomposition characteristics of two groups of representative mixed malodorants (1, ethanethiol + hydrogen sulfide; 2, ethanethiol + ammonia) in air were investigated employing a wire-plate pulse Corona reactor. A new type of high-voltage pulse generator with a thyratron switch and a Blumlein pulse-forming network (BPFN) was used in our experiments. The experiments were conducted at a gas-flow rate of, 13 m(3)/h. Important parameters, including peak voltage, chemical structures of malodorants, pulse frequency, and initial concentration, which influenced the removal efficiency, were investigated. The results showed that the mixed malodorants could be treated effectively by pulse Corona. The removal efficiencies of 200 mg/m(3) C2H5SH and 200 mg/m(3) H2S for group I were 95.6% and 100%, respectively, which were almost equal to those of the two pollutants separately. The energy cost was about 65.1-81.4 A, which was 31.5-45.2% lower than for treating pollutants alone. The removal efficiencies of 105 mg/m(3) C2H5SH and 40 mg/m3 NH3 for group 2 were 93.1% and almost 100%, and the energy cost was 65.1 J/L, 55.6% lower than that which was treated separately. In the case of two groups of mixed malodorants removal, NO,, O-3, SO2, CO2, and CO were all observed. Moreover, some sulfur and white crystal ammonium nitrates were discovered adhering to the Corona wires in the removal of groups 1 and 2, respectively. A dynamics model was developed to describe the relation of the removal efficiency with specific energy density and initial concentration. In the case of group 1 removal,the decomposition rate constants decreased as compared to the single treating. As for group 2 removal, the decomposition rate constants increased, especially for NH3. According to the results, the optimization design for the reactor and the matching of high pulse voltage source can be reckoned.

Odor removal characteristics of a laminated film-electrode packed-bed nonthermal plasma reactor

Abatement of Malodorants from Pesticide Factory in Dielectric Barrier Discharges.

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Wipe out of Stench from Landfill Leachate by Non-Thermal Plasma Combined with Blow-off

VOCs degradation with non-thermal plasma and Ag-MnOx catalysis

Decomposition of mixed malodorants in a wire-plate pulse corona reactor.

Decomposition of Simulated Odors in Municipal Wastewater Treatment Plants by a Wire-Plate Pulse Corona Reactor.

Removal of Volatile Organic Compounds (vocs) at Room Temperature Using Dielectric Barrier Discharge and Plasma-Catalysis

Removal of ammonia from gas streams with dielectric barrier discharge plasmas

Optimization for Plasma-facilitated Catalytic Reduction of NO_x

Novel Multineedle-to-cylinder Plasma Coupled with Bimetallic Catalysts for Efficient Removal of Sulfides and Ammonia in Odor Gases

Experimental Studies of Removing Typical VOCs by Dielectric Barrier Discharge Reactor of Different Sizes

NOx removal by non-thermal plasma reduction: experimental and theoretical investigations

Abatement of gas-phase VOCs via dielectric barrier discharge plasmas

Nitrogen Oxides Removal and Mechanism Research for Dielectric Barrier Discharge with NaCl Solution Grounded Electrode

Simultaneous Treatment of Various Malodorous Substances in Gas by Non-Thermal Plasma

Nonthermal plasma: An emerging innovative technology for the efficient removal of cooking fumes

Visualization of In Situ Oxidation Process Between Plasma and Liquid Phase in Two Dielectric Barrier Discharge Plasma Reactors Using Planar Laser Induced Fluorescence Technique

In Plasma Catalytic Oxidation of Toluene Using Monolith CuO Foam As a Catalyst in a Wedged High Voltage Electrode Dielectric Barrier Discharge Reactor: Influence of Reaction Parameters and Byproduct Control

Indoor air quality improvement and purification by atmospheric pressure Non-Thermal Plasma (NTP)

Characteristics of Ammonia Oxidation in a Dielectric Barrier Discharge Reactor