Abstract:This study investigated the capillary rise potential and dynamic behavior of rubber particles-silty sand mixtures. A series of capillary rise tests and undrained cyclic triaxial tests were designed and performed on pure silty sand and rubber soil mixtures. The impact of rubber particles content (RC) and mean grain size ratio (D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document}) of the mixtures was investigated. The results showed that the increase of RC and D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document} decreased the capillary rise behavior. Compared with pure silty sand, the total capillary water mass increment of mixtures with 30% rubber particles with 41.3 and 7.9 D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document} decreased by 52.7% and 35.1%, respectively. An increase in D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document} resulted in a harder performance for the mixtures, whereas an increase in RC resulted in softer performance for the mixtures. Compared with pure silty sand, the maximum Young’s modulus of mixtures with 30% rubber particles (at 200 kPa confining pressure) for 41.3 and 7.9 D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document} decreased by 52.7% and 35.1%, respectively. An increase in the normalized Young’s modulus was associated with a decrease in RC\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$\mathrm{RC}$$\end{document} and increase in D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document}. An increase in RC\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$\mathrm{RC}$$\end{document} and decrease in D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document} resulted in an increase in damping ratio. A set of empirical equations was proposed to describe the normalized Young’s modulus and damping ratio. The results presented here provide new ideas for the use of rubber soil mixtures in geotechnical engineering.

Factors Influencing the Dynamic Shear Modulus and Damping Ratio of Granulated Rubber–Clay Mixtures in Xiong'an New Area

Micromechanical Investigation of the Shear Behaviors of Sand‒rubber Mixtures Using a Multibody Meshfree Method

Shear Behaviour of Sand-Rubber Mixtures: Interpretation from Energy Transformation and Force Chain Evolution

Evaluation of dynamic shear modulus and damping ratio of rubber-sand mixture based on cyclic simple shear tests

Experimental Study on Dynamic Modulus and Damping Ratio of Rubber-Sand Mixtures over a Wide Strain Range

Dynamic Properties of Silty Sand Mixed with Rubber Particles for Medium Strain

Dynamic shear modulus and damping ratio of rubber-sand mixtures with a wide range of rubber content

Experimental Study on Dynamic Elastic Modulus and Damping Ratio of Xiaoshan Saturated Soft Clay Considering Initial Deviator Stress

EXPERIMENTAL RESEARCH ON CHANGING RULES OF DYNAMIC MODULUS AND DAMPING RATIO OF SATURATED SOFT CLAY UNDER BIDIRECTIONAL EXCITING CYCLIC LOADING

Dynamic Modulus Characteristics of Saturated Clays under Variable Confining Pressure

Shear Modulus and Damping Ratio of Sand–Gravel Mixtures Over a Wide Strain Range

Effect of the particle size ratio on macro- and mesoscopic shear characteristics of the geogrid-reinforced rubber and sand mixture interface

Dynamic Properties of Composite Cemented Clay.

Dynamic properties of frozen rubber-reinforced expansive soils under confining pressure

Cyclic and Dynamic Behavior of Sand–Rubber and Clay–Rubber Mixtures

EFFECT OF PARTICLE SIZE RATIO AND MIX RATIO ON MECHANICAL BEHAVIOR OF RUBBER-SAND MIXTURES

Stress–strain–strength behavior of geosynthetic reinforced rubber–sand mixtures

Experimental Investigation on the Compressive Behavior of Rubber–Sand Mixtures under Repeated Loading–Unloading

Mechanical Behaviour of Completely Decomposed Granite Soil with Tire Rubber Granules and Fibres

Microstructure and Meso-Mechanical Properties of Asphalt Mixture Modified by Rubber Powder under a Multi-Scale Effect

Experimental Study on Static and Dynamic Characteristics of Sand–Clay Mixtures with Different Mass Ratios