Abstract:Silicon monoxide (SiOx, x ∼ 1) has emerged as a highly promising candidate for high-energy-density lithium-ion batteries due to its high specific capacity and suitable working potential. Nevertheless, the formation of a large quantity of irreversible products, such as Li2O and lithium silicates, during the initial lithiation process results in a low initial coulombic efficiency (ICE) of SiOx, which is a significant impediment to its commercial application. To overcome this limitation, two lithium aromatic complexes, namely, lithium-naphthalene-2-methyl-tetrahydrofuran (N-LAC) and lithium-biphenyl-2-methyl-tetrahydrofuran (B-LAC), with a low redox potential are used to pre-lithiate SiOx anodes. The differences in lithiation kinetics and efficacy of the two LAC solutions are identified and assessed by scrutinizing the pre-lithiation process of SiOx materials. It is revealed that both pre-lithiation agents produce solid electrolyte interphase (SEI) films on the material surface enriched with substances such as LiF, Li2CO3, and ROCO2Li, but the LiF content in the SEI of the N-LAC pre-lithiated electrode is significantly higher. Furthermore, the surface roughness of the N-LAC pre-lithiated electrode is lower, and the horizontal distribution of mechanical properties and surface potential tend to be more homogeneous, even during cycling, at approximately the same degree of lithiation. The results indicate that the N-LAC solutions not only improve the ICE of the SiOx material but also optimize the interfacial and structural stability of the SiOx electrode. When the pre-lithiated SiOx anode is paired with lithium-rich layered oxide cathode materials, the energy density and ICE are significantly improved compared to the cell using pristine SiOx anode.

Insights to the variation of oxygen content and reasons for improved electrochemical performance of annealing SiOx anodes for Li-ion battery

Influence of oxygen content on the electrochemical behavior of SiOx@C anodes for Li-ion battery

Three-dimensional Dual-Layered Conductive Binder Enables Stable and High Performance of SiOx/C Anodes

Controlling of the Ratio of Submicron Particles and Size Effects in SiO Anode for Li-ion Batteries

High Performance SiOx Anode Enabled by AlCl3-MgSO4 Assisted Low-Temperature Etching for Lithium-Ion Batteries

Pre-lithiation synergized with magnesiothermic reduction to enhance the performance of SiO anode for advanced lithium-ion batteries

Robust and Fast‐Ion Conducting Interphase Empowering SiO x Anode Toward High Energy Lithium–Ion Batteries

Boosting the initial coulombic efficiency for SiO anodes through component controlling and microcrystalline size limiting regulated by carbon layer

Chemical Pre-lithiation of SiO x Anodes with a Weakly Solvating Solution of Polycyclic Aromatic Hydrocarbons for Lithium-Ion Batteries

Engineering molecular regulation for SiOx with long-term stable cycle and high Coulombic efficiency as lithium-ion battery anodes

Manipulating Oxidation of Silicon with Fresh Surface Enabling Stable Battery Anode

An Effective Strategy on Synthesizing a Stable SiOx‐Based Anode for High Density Lithium‐Ion Batteries

Potassium Ions Regulated the Disproportionation of Silicon Monoxide Boosting Its Performance for Lithium-Ion Battery Anodes

Li-Si alloy pre-lithiated silicon suboxide anode constructing a stable multiphase lithium silicate layer promoting Ion-transfer kinetics

High Initial Coulombic Efficiency of SiO Enabled by Controlling SiO2 Matrix Crystallization

Sn Alloy and Graphite Addition to Enhance Initial Coulombic Efficiency and Cycling Stability of SiO Anodes for Li‐Ion Batteries

Improved electrochemical performance of silicon monoxide anode materials prompted by macroporous carbon

Modifying SiO @ C As High-performance Anode of Lithium-ion Batteries

SiOx/C anodes with high initial coulombic efficiency through the synergy effect of pre-lithiation and fluoroethylene carbonate for lithium-ion batteries

Focusing on the Subsequent Coulombic Efficiencies of SiO<i><sub>x</sub></i>: Initial High-Temperature Charge after Over-Capacity Prelithiation for High-Efficiency SiO<i><sub>x</sub></i>-Based Full-Cell Battery

Systematic electrochemical characterizations of Si and SiO anodes for high-capacity Li-Ion batteries