Abstract:Background and objectives: Laser surgical procedures involving photocoagulation of soft tissue have relied on subjective visual endpoints. The thermal damage to the denatured tissue in these procedures is highly dependent on the tissue temperatures achieved during laser irradiation. Therefore, a system capable of real time temperature monitoring and closed loop feedback was used to provide temperature controlled photocoagulation (TCPC). Study design/materials and methods: The TCPC system consisted of a 1.32 microns Nd:YAG laser, an infrared thermometer, and a microprocessor for data acquisition and feedback control. A porcine skin model was used. Tissue welds were completed to evaluate the photocoagulation effects at different predetermined temperatures. A quantitative measurement of tissue photocoagulation was obtained by tensile strength measurements of the laser repairs. Histology of the irradiated tissue was used to determine the extent of thermal injury associated with different photocoagulation temperatures. Results: The TCPC system was capable of maintaining a relatively constant temperatures (+/- 4 degrees C) during laser irradiation. The tensile strengths of acute repairs increased with temperature over the range studied (65-95 degrees C). Tensile measurements made after several days of healing showed that higher temperature (95 degrees C) welds had lower strengths than repairs completed at lower (65 degrees C or 75 degrees C) temperatures and were significantly lower at 3 days. Acute histology showed that the amount thermal damage was strongly dependent on the tissue temperature and increased both in tissue depth and lateral to the repair with temperature. The histologic results suggest that the increase in the acute repair tensile strength as the weld temperature increased was due to an increase in the depth of tissue photocoagulation. The increase in the lateral tissue injury measured histologically for higher temperature welds likely resulted in the decreased chronic tensile strengths, as a healing response to excessive thermal damage. Conclusion: Tissue temperatures can be controlled during laser photocoagulation of skin. The degree of acute and chronic tissue damage is highly dependent on the temperature during welding. By controlling the tissue temperature during laser procedures, the surgical outcome can be more reliably predicted and reproduced, as compared to the conventional open loop methods. In addition, the use of a TCPC system should significantly reduce the learning curve for photothermal surgical procedures.

Three‐dimensional reconstruction of deferent ducts papillae in urogenital duct system of the male rat

Laser assisted vascular welding with real time temperature control

Axial temperature control device for copper halide laser

Temperature-controlled laser photocoagulation of soft tissue: in vivo evaluation using a tissue welding model

A temperature control system for laser welding of plastics differing in optical parameters

Evidence for a common structure for a class of membrane channels.

Evaluation of a pyrometric-based temperature measuring process for the laser transmission welding

Effect of optical temperature feedback control on patency in laser-soldered microvascular anastomosis

Controlled temperature tissue fusion: argon laser welding of rat intestine in vivo. Part one

Temperature Distribution of Vessel Tissue by High Frequency Electric Welding with Combination Optical Measure and Simulation

Controlled temperature tissue fusion: argon laser welding of canine intestine in vitro

Infrared observations and finite element modeling of a laser transmission welding process

Three-Dimensional Transient Simulation of Laser Deep-penetration Welding Based on Combined Heat Source

Two-Color-Thermography for Temperature Determination in Laser Beam Welding of Low-Melting Materials

Numerical simulation of thermo-mechanical coupling in laser-MIG hybrid welding utilizing dual volume heat sources

A Thermal Analysis of LASER Beam Welding Using Statistical Approaches

Modeling of Conduction Mode Laser Welding Process For Feedback Control

Studentized Dynamical System for Robust Object Tracking

Accelerated membrane-assisted clean-up as a tool for the clean-up of extracts from biological tissues.

Finite element simulation of laser transmission thermoplastic welding of circular contour using a moving heat source

Validating a simulation model for laser-induced thermotherapy using MR thermometry