Abstract:This study develops a silicon-based microfluidic device incorporating a micro reformer that employs the partial oxidation of methanol (POM) reaction and a microchannel heat exchanger (MCHE) for potential reforming methanol fuel cell application. Two-dimensional temperature distribution of the reformer and two-phase flow evolution in the MCHE are acquired by infrared (IR) thermography and high-speed digital camera images, respectively. The composition of gas products is further analyzed by gas chromatography. The maximal hydrogen production rate of 2.97 x 10(-5) molls and selectivity of 77.3% are obtained in the present study. Thermal images of the reformer indicate that the POM reaction is more intense near the outlet, and the high-temperature region expands from the outlet to inlet regions with time until the steady state is reached. The present study reveals that IR thermography with proper calibration facilitates real-time temperature monitoring, which enables understanding the distribution of the reforming reaction and its evolution through the reformer until the steady state is reached. The shortest time for approaching the steady state is only 8 s for the present system under certain conditions. The data obtained may provide a basis for theoretical and numerical analyses on the progress of temperature and reforming reaction. In addition, the present results demonstrate that the micro evaporator may effectively use the heat produced from the exothermic POM reaction and provide low-temperature hydrogen for possible application in fuel cells. (C) 2016 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

A Pd/Al2O3-based micro-reformer unit fully integrated in silicon technology for H-rich gas production

Standalone ethanol micro-reformer integrated on silicon technology for onboard production of hydrogen-rich gas

An Innovative Micro-Channel Catalyst Support with a Micro-Porous Surface for Hydrogen Production Via Methanol Steam Reforming

Standalone micro-reformer for on-board hydrogen production from dimethyl ether

A Micro-Reactor with Micro-Pin-fin Arrays for Hydrogen Production Via Methanol Steam Reforming

A Thermally Autonomous Methanol Steam Reforming Microreactor with Porous Copper Foam As Catalyst Support for Hydrogen Production

LOW TEMPERATURE POM MICRO-REFORMER WITH SILICON NANO-WIRE SUPPORTED NANO CATALYSTS

A novel thermally autonomous methanol steam reforming microreactor using SiC honeycomb ceramic as catalyst support for hydrogen production

Development of Methanol Steam Reforming Microreactor Based on Stacked Wave Sheets and Copper Foam for Hydrogen Production

A Robust Flat-Chip Solid Oxide Fuel Cell Coupled with Catalytic Partial Oxidation of Methane

Co-Generation of Electricity and Syngas on Proton-Conducting Solid Oxide Fuel Cell with A Perovskite Layer As A Precursor of A Highly Efficient Reforming Catalyst

A High-Yield and Ultra-Low-temperature Methanol Reformer Integratable with Phosphoric Acid Fuel Cell (PAFC)

Performance Enhancement on A Micro-Column Structure Reformer Via Thick-Film Photoresist Pre-Protection

Hydrogen Production from Cylindrical Methanol Steam Reforming Microreactor with Porous Cu-Al Fiber Sintered Felt

Structured Catalyst for Indirect Internal Reforming (IIR) of Biogas in Solid Oxide Fuel Cell (SOFC)

Microdrop-confined synthesis and regulation of porous hollow Ir-based catalysts for the mass transfer-enhanced electrolysis of pure water

Porous Silicon Oxycarbonitride Ceramics with Palladium and Pd2Si Nanoparticles for Dry Reforming of Methane

Hydrogen Production Of A Heavy Hydrocarbon Fuel Autothermal Reformer On Nio-Rh Based Monolithic Catalysts

Real-time Monitoring of a Micro Reformer Integrated with a Microchannel Heat Exchanger by Infrared Thermography and High-Speed Flow Images

LaMnO3-Type Perovskite Nanofibers as Effective Catalysts for On-Cell CH4 Reforming via Solid Oxide Fuel Cells

Sorption-enhanced propane partial oxidation hydrogen production for solid oxide fuel cell (SOFC) applications