Abstract:With the continuous innovation and improvement of electronic information and systems, the transmission power in the equipment is also increasing. For the propagation of high-power microwaves, not only the transmission characteristics of high-power microwaves should be considered, but also the protection measures should be taken to prevent the damage caused by excessive pulses on the back-end equipment. In this article, the characteristics of waveguide plasma limiter are studied based on the plasma formed by low pressure microwave gas discharge, which reflects and absorbs electromagnetic waves. At the same time, in response to the potential power leakage problem of single-stage plasma limiters in protecting high-power microwaves, a protective device is proposed for the combination of plasma limiters and PIN limiters in rectangular waveguides. When the incident microwave intensity is strong, the electronic components are protected from burning by plasma. When the front-end plasma limiter fails to exert its effect and causes power leakage, the transmitted microwave energy is attenuated by the subsequent PIN diode limiter circuit, causing its strength to fall below the safety threshold. This limiter system model can be controlled and described by the electromagnetic (EM) fields, plasma physics and PIN equivalent circuit model. In the multi-physics cascaded waveguide limiter system, the spectral-element time-domain (SETD) method is used for system integration and self-consistent simulation analysis. The results show that the limiting performance of the cascaded limiter is much better than that of the single-stage plasma limiter under the action of HPM pulses. This research provides theoretical guidance for the use of plasma limiting devices to protect against high-power microwave damage.

A reflective mm-wave photonic limiter

Ultrathin broadband reflective optical limiter

Reflective Optical Limiters: Ultrathin Broadband Reflective Optical Limiter (laser Photonics Rev. 15(6)/2021)

Experimental Realization of a Reflective Optical Limiter

Self‐Excited Free‐Standing VO2 Film for Infrared Optical Limiter

Ultra‐High Transmission Broadband Tunable VO2 Optical Limiter

Limiting optical diodes enabled by the phase transition of vanadium dioxide

Optical Power Limiters Based on Frequency-Selective Surfaces and Phase-Transition Materials

Design and Analysis of an Adjustable Diode-Integrated Waveguide-Based Electromagnetic Pulse Limiter for Microwave Receiver

Waveguide photonic limiters based on topologically protected resonant modes

A Low Power Threshold, Ultrathin Optical Limiter Based on a Nonlinear Zone Plate

Optical Limiter Based on PT-Symmetry Breaking of Reflectionless Modes

Digitally Controlled Programmable High‐speed Variable Optical Attenuator

Electrically tunable VO 2 –metal metasurface for mid-infrared switching, limiting and nonlinear isolation

Development of the Plasma Limiter for High Power Microwave Weapon Protection

Reflective nonlinear optical limiter design based on coupled Tamm plasmon polaritons and optical Kerr effect

Optical Limiter with an Organic Solution Sandwiched Between a Polymer Slab and a Polymer Grating

Electrically tunable VO2-metal metasurface for mid-infrared switching, limiting, and nonlinear isolation

Systematic Investigation of Millimeter-Wave Optic Modulation Performance in Thin-Film Lithium Niobate

Broadband optical power limiter metalens

Simulation of Simplified Cascade Waveguide Plasma Limiter under High Power Microwave