Abstract:The combination of plastic scintillators with Silicon Photo-Multipliers (SiPMs) is widely used for detecting radiation in high-energy astrophysics, particle physics, neutrino physics, or medical physics. An example of application for this kind of detectors are Compton polarimeters such as POLAR-2 or LEAP, for which a low-Z material is needed for the Compton effect to be dominant down to as low energy as possible. Such detectors aim to measure low energy Compton depositions which produce small amounts of optical light, and for which optimizing the instrumental optical properties consequently imperative. The light collection efficiency of such a device was studied with a focus on the POLAR-2 GRB polarimeter, in which the conversion of incoming $\gamma$-rays into readable signal goes through the production and collection of optical light, which was to be optimized both through measurements and simulations. The optical elements of the POLAR-2 polarimeter prototype module were optically characterized and an optical simulation based on Geant4 was developed to fully model its optical performances. The results from simulations were used to optimize the design and finally to verify its performance. The study resulted in a detector capable of measuring energy depositions of several keV. In addition an important finding of this work is the impact of the plastic scintillator surface roughness on the light collection. It was found that a plastic scintillator with a higher scintillation efficiency but made of a softer material, hence with a rougher surface, was not necessarily the best option to optimize the light collection. Furthermore, in order to optimize the optical crosstalk between different channels, a production technique for very thin ($\sim$150$~\mu$m) and reusable silicone-based optical coupling pads, which can be applied for other experiments, was developed.

Light simulation in plastic scintillator strip with embedded wavelength shifting fiber

Light yield and radiation hardness studies of scintillator strips with a filler

Optimization of light yield by injection of the optical filler into the co extruded hole of plastic scintillation bar with WLS fiber in it

Position-dependent light yield in short, coated SCSF-78 scintillating fibers

Wavelength-shifter coated polystyrene as an easy-to-build and low-cost plastic scintillator detector

Scintillation light simulation in big-sized BaF$_{2}$ and pure CsI crystals

Design optimization of JUNO-TAO plastic scintillator with WLS-fiber and SiPM readout

Light output simulation of LYSO single crystal

Characterization of Plastic Scintillator Samples Produced by a University-SME Collaboration

Design Optimization of Plastic Scintillators with Wavelength-Shifting Fibers and Silicon Photomultiplier Readouts in the Top Veto Tracker of the JUNO-TAO Experiment

Study in the Optical Performance of Plastic Scintillator with WLS Fiber

Adiabatic Light Guide with S-shaped Strips

Performance of a plastic scintillator developed using styrene monomer polymerization

Low Energy Light Yield of Fast Plastic Scintillators

Directional light outcoupling enhancement of scintillators via hollow microlens arrays

Optimizing the light output of a plastic scintillator and SiPM based detector through optical characterization and simulation: A case study for POLAR-2

Performance simulation study of plastic scintillator arrays for stability monitoring applications

Light propagation and fluorescence quantum yields in liquid scintillators

Performance of styrene polymerized plastic scintillator with micropixel avalanche photodiode

Full‐Inorganic Micro‐Fiber Probe for Real‐Time Radiation Monitoring

On the origin of the light yield enhancement in polymeric composite scintillators loaded with dense nanoparticles