Abstract:Electricity generated from renewable energy source fluctuates heavily and can hardly be predicted. The peak shaving (or load cycling) operation of conventional thermal power plants is an effective means to mitigate the mismatch between electricity demands and supplies. Therefore, determining how thermal power plants can operate in a flexible and effective mode is an urgent issue that should be addressed. For thermal power plants, new methods and strategies need to be proposed to face the challenge of the integrating flexibility and energy saving into transient processes. Dynamic performances of thermal power plants during load cycling processes are affected by the coupling of the thermal system and the control system. Feasible approaches from optimizing the coordinated control system (CCS) may radically enhance the peak shaving capacity of thermal power plants. The heat storage in a coal-fired power plant, including heating surface metals and work media, varies with the load rate of the plant. During cycling load operations, the real-time heat storage value of one unit differs from that of the corresponding steady state load command rate. This difference hinders the flexibility of one unit and affects its economic performances during cycling processes. In this paper, a revised water fuel ratio (WFR) control strategy based on heat storage difference was proposed and tested on established coal-fired power plant models. Results show that the accumulation deviations of load rate command and real-time load rate are considerably reduced during load cycling processes when the proposed WFR control strategy is introduced. The revised WFR control strategy diminishes the difference between the target and the actual total power output. When the load cycling rate varies from 10 to 30 MW min(-1) between 50% and 100% THA, the standard coal consumption variation rate (Delta b(s),) decreases by 0.31-1,01 g kW(-1) h(-1) during loading up processes, and decreases by 0.26-1.69 g kW(-1) h-(1) during loading down processes.

Economic analysis of peak-shaving sliding pressure operation of 300 MW unit in Shajiao A Power Station

Economic Analysis of Peak Shaving Sliding Pressure Operation of 660MW Unit

Parameters analysis of 600 MW + 120 MW peak load unit by integrated generate technology

ANALYSIS ON THE PERFORMANCE OF COMPOSITE HEAT-ACCUMULATION AND POWER-GENERATION TECHNOLOGY IN THERMAL POWER PLANT

Analysis on Influence Factors of Fast Valving of Control Valve of Supercritical Unit on Promoting Transient Stability

Experimental Study on Peak-shaving Ability of a 330MW Thermal Power Unit in Heating State

Performance Analysis of a 300 MW Coal-Fired Power Unit during the Transient Processes for Peak Shaving

The Thermal Economic Evaluation for Sliding Pressure Operation in 330MW Steam Turbine

A Variable Condition Calculation Method for Thermal Power Units Sliding Pressure Operation

Probing of operation economy for coal-fired unit under low loads with two fixed boundary conditions

Impact of the Running Modes of Coal-Fired Units on Energy Consumption in in-Depth Peak Load Cycling

Economic Analysis of Thermal Power Plants Considering Hidden Costs in Deep Peak Shaving

Evaluation of Combined Heat and Power Plants with Electricity Regulation

Study on an on-line monitoring method for peak shaving capacity of thermal power unit

Economic Analysis of a 660MW Supercritical Turbine for Steam Initial Parameters

A Mixed Integer Linear Programming Model for Unit Commitment of Thermal Plants with Peak Shaving Operation Aspect in Regional Power Grid Lack of Flexible Hydropower Energy

Peak Shaving Operational Optimization of Supercritical Coal-Fired Power Plants by Revising Control Strategy for Water-Fuel Ratio

Analysis of the Operational Behavior of a 600MW Steam Turbine Set's Main Stop and Governing Valve System

Economic Analysis of Deep Peak-Shaving Reform of 600MW Thermal Power Unit in Beijing-Tianjin-Tangshan Power Grid

Thermo-economic analysis of the integrated bidirectional peak shaving system consisted by liquid air energy storage and combined cycle power plant

The Economic Benefits Simulation of Peak Load Shifting in Pumped Storage Power Plant