Abstract:Currently, there is a scarcity of studies exploring the safe operating parameters for coal-fired power units at loads below 30%.To accurately understand the operating characteristics of coal-fired units under low load conditions, and to provide a design basis for flexibility modifications, a simulation model coupled with boiler and turbine was established, which includes the flue gas and air system, steam and water system, steam turbine, and steam extraction heat recovery system, and the iterative calculation strategy for low load conditions was proposed. The simulation calculation was performed on a 350 MW supercritical coal-fired unit, with the model results showing a high degree of alignment with the unit’s design and operational parameters. Under the condition of 269MW, the maximum calculation error between the model’s predicted exit flue gas temperature of the air preheater and the actual operational results was 8.84%. This discrepancy was due to a sudden increase in the operating flue gas temperature, which may be associated with a blockage in the air preheater. And the simulation results under low load conditions indicate that when the unit load is below 20%, the furnace total airflow is controlled to no less than 30% of the airflow at Maximum Continuous Rating (BMCR) and the minimum feedwater flow rate can be reduced to 20% of that in Turbine Heat Acceptance (THA) load, and the unit switches to wet state operation around 20% load. As the unit load decreases, the coal consumption rate for power generation and steam turbine heat consumption rate both increase significantly. The coal consumption rate for power generation at 30% load is increased by 13.3% compared to BMCR load, and it is increased by 32.5% at 15% load which is operated in wet state. Under low load conditions, the coal consumption rate of the unit can be reduced by decreasing the oxygen content in the flue gas, reducing the minimum feedwater flow rate, and implementing boiler water recirculation.

A Variable Condition Calculation Method for Thermal Power Units Sliding Pressure Operation

Performance Design of a Cryogenic Air Separation Unit for Variable Working Conditions Using the Lumped Parameter Model

Online Energy-Loss Analysis System for Thermal Power Generating Unit of Piping-Main Scheme

Economic analysis of peak-shaving sliding pressure operation of 300 MW unit in Shajiao A Power Station

Thermodynamic Analysis of Coal-Fired Thermal Power Units Coupled S-CO2 Energy Storage System

Correcting and Calculating the Effect on Turbine Power of Exhaust Pressure Variation for Condensing Steam Turbine

An Optimization Method of Steam Turbine Load Resilient Adjustment by Characterizing Dynamic Changes in Superheated Steam Energy

Comparison of Three Calculating Procedures for Thermodynamic Parameters under Variable Operating Conditions of High-power Turbine

LINEAR METHOD FOR THE THERMAL ECONOMICAL ANALYSIS OF SUPERCRITICAL PRESSURE POWER PLANT WITH DOUBLE REHEAT

State variable-fuzzy prediction control strategy for superheated steam temperature of thermal power units

A Thermo-Economic Analysis Method for Combined Cycle Power Plants under Flexible Operation Modes

Model and Algorithm for Thermal Performance Calculation of Power Station Boiler Based on Process Steady-State Simulation Theory

Operation Data Based Modelling And Optimization Of Thermal Power Units Under Full Working Conditions

Performance Analysis of a 300 MW Coal-Fired Power Unit during the Transient Processes for Peak Shaving

Experimental Study on Peak-shaving Ability of a 330MW Thermal Power Unit in Heating State

Probing of operation economy for coal-fired unit under low loads with two fixed boundary conditions

A real-time monitoring model for heat consumption rate of steam turbine unit based on unit power

A Real-Time Calculation Method to Improve Boiler Safety in Deep Peak Shaving Cases

Simulation of low-load operation for a 350 MW supercritical unit

Research on Online Thermal Calculating Method of Thermal DynamicSystem for Power Plant

Calculation method research of power supply coal consumption of coal-fired cogeneration unit