Abstract:TiB whisker-reinforced TiBW/TC4 composites are widely used in the aviation, aerospace, automobile, and various other industries. However, the drilling force and temperature affect a lot on the drilling micromechanical properties of TiBW/TC4 composites. In order to reveal the microscale thermodynamic properties of the composite and promote the optimization of drilling processing, a representative volume element (RVE) model of the composite was built in the Digimat-FE software tool to determine the micromechanical properties and failure mechanism of TiBW/TC4 composites. Based on drilling experiments, the simulation load and boundary conditions were defined. Then, the effects of drilling force and temperature on the micromechanical properties of the composite and the laws of thermodynamics governing TiBW/TC4 composites were carefully analyzed under three different working conditions: pure drilling force, pure drilling temperature load, and drilling force/temperature load. The results show that with the drilling force rapidly increasing, the maximum stress occurs within the reinforced phase of the composite during the drilling process, whereas the minimum stress appears within the basket matrix region of the reinforced phase. Strains in the matrix were clearly higher than in the whiskers. Stability within the composite material was compromised as the matrix began to fail. The drilling force was shown to be the main reason for failure of the material, whereas the drilling temperature did not appear inherently weaken the material structure, but can, in fact, slow down the impact of the drilling force. When the drilling force began to slowly decrease and tended to stabilize, the stress slowly decreased as well. Although the stress on the whiskers was higher than the matrix stress, the difference value between whiskers and the matrix was constantly shrinking, and the stress of the whole model tended to be uniform.

Molecular Dynamics Study on Drilling Performance and Cutting Behavior of Fe–Bi Free-Cutting Steel

Effects of bismuth nanoparticles on the nano-cutting properties of single-crystal iron materials: a molecular dynamics study

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Influence of Tool Geometrical Parameters on High Speed Cutting of Titanium Alloy Ti6Al4V

Effects of bismuth particle inclusions on surface and internal wear of single crystal iron: A molecular dynamics simulation

Study on the Orthogonal Cutting Process of Al7050T7451 with Uncoated and Coated Tools

Molecular dynamics simulation of cutting mechanism of polycrystalline Fe-Cr-W alloy

Effects of MnS inclusions on mechanical behavior and damage mechanism of free-cutting steel: A molecular dynamics study

High-speed drilling mechanism study of unidirectional CoCrFeNiAl fiber-reinforced aluminum matrix composites

Research on the effect of cutting parameters on the machinability of polycrystalline Fe-Cr-W alloy by molecular dynamics simulation

Effect of dislocation density distribution in work-hardened layer on cutting characteristics in the multi-cutting of 49Fe49Co2V alloy

Molecular Dynamics Simulation Study on the Influence of the Abrasive Flow Process on the Cutting of Iron-Carbon Alloys (α-Fe)

Analysis of the effect of tool geometry on the cutting process of polycrystalline Fe-Cr-W alloy based on molecular dynamics simulation

Effect of Workpiece Atom Diffusion Into CBN Tool on Its Mechanical Properties in Cutting Ni–Fe–Cr Alloy Based on Molecular Dynamics Simulation

Research on Deep-Hole Drilling of High-Strength Steel Using Slender Gun Drill

BTA Deep Hole Vibration Drilling for Nickel-Based Alloys: Cooling Patterns and Cutter Tooth Wear Mechanisms

The Influence of Carbides on Atomic-Scale Mechanical Properties of Carbon Steel: A Molecular Dynamics Study

Behaviors of novel manufacturing 1215MS+Bi steel in casting thermal processes

Effect of 1wt.%Bi addition on microstructure and mechanical property of Mg–3Al alloy by twin roll casting and hot rolling

Research on the drilling micromechanical properties of TiBW/TC4 composites based on drilling force and temperature analysis

Molecular dynamics simulation of the influence of nanocutting parameters on microstructure of AISI M2