Abstract:A comprehensive procedure for the derivation of optimal, full-operating-range zero voltage switching (ZVS) modulation schemes for single-phase, single-stage, bidirectional and isolated dual active bridge (DAB) ac–dc converters is presented. The converter topology consists of a DAB dc–dc converter, receiving a rectified ac line voltage via a synchronous rectifier. The DAB comprises primary and secondary side full bridges, linked by a high-frequency isolation transformer and a series inductor. ZVS modulation schemes previously proposed in the literature are either based on current-based or energy-based ZVS analyses. The procedure outlined in this paper for the calculation of optimal DAB modulation schemes (i.e., combined phase-shift, duty-cycle, and switching frequency modulation) relies on a novel, more accurate, current-dependent charge-based ZVS analysis, taking into account the amount of charge that is required to charge the nonlinear parasitic output capacitances of the switches during commutation. Thereby, the concept of “commutation inductance(s)” is shown to be an essential element in achieving full-operating-range ZVS. The proposed methods are applied to a 3.7 kW, bidirectional, and unity power factor electric vehicle battery charger which interfaces a 400 $\hbox{V}$ dc-bus with the $\hbox{230} \hbox{V}_{{\rm ac}}$, 50-Hz utility grid. Experimental results obtained from a high-power-density, high-efficiency converter prototype are given to validate the theoretical analysis and practical feasibility of the proposed strategy.

Closed-Form Continuous Asymmetrical Hybrid Modulation, Ensuring Wide ZVS Range and Seamless Transients for DAB Converters

ZVS Operation of DAB Converter Based on Triple-Phase-shift Modulation Scheme with Optimized Inductor Current

Novel ZVS S-TCM Modulation of Three-Phase AC/DC Converters

Wide-Load Range Multiobjective Efficiency Optimization Produces Closed-Form Control Solutions for Dual Active Bridge Converter

Closed-Form Solution for Efficient ZVS Modulation of DAB Converters

A Novel Symmetrical Boost Modulation Method for qZS-based CHB Inverters

A Hybrid Five-Variable Modulation Scheme for Dual-Active-Bridge Converter With Minimal RMS Current

Artificial-Intelligence-Based Hybrid Extended Phase Shift Modulation for the Dual Active Bridge Converter with Full ZVS Range and Optimal Efficiency

An Analog-based, Duty Cycle Modulation Method to Remove the DC Bias in the Transformer for a Dual Active Bridge Converter

Hybrid Duty Modulation for Dual Active Bridge Converter to Minimize RMS Current and Extend Soft-Switching Range Using the Frequency Domain Analysis

Optimal ZVS Modulation of Single-Phase Single-Stage Bidirectional DAB AC–DC Converters

Towards Full Range Zero-Voltage Switching of DAB Converters: An Improved Multi-Mode Modulation at Light Loads Under Close-to-Unity Voltage Ratio

Comprehensive analysis of asymmetric modulated Dual-Active-Bridge converter and its Hybrid control strategy

A Collaborative Modulation Method of Dual-Side Backflow Power Optimization and Zero-Voltage Switching for Dual Active Bridge

Extension of Zero-Voltage Switching Region of Wide Volage Ratio Range Dual-Active-Bridge Converter by LC Antiresonant Network

Modulation of 2/3-Level Dual-Active-Bridge DC-DC Converters for Soft-Switching and Minimum Current Stress.

A Novel Current Modulation Method to Eliminate Low-Frequency Harmonics in Single-Stage Dual Active Bridge AC–DC Converter

A ZVS Range Enhancement Strategy for the DAB Converter by Using Blocking Capacitors

Influence of Junction-Capacitance and Dead-Time on Dual-Active-Bridge Actual Soft-Switching-Range: Analytic Analysis and Solution

Improved hybrid current modulation for bidirectional power flow of single-stage dual active bridge AC/DC converter

A Phase Shift Control of Minimal Circulating Current and ZVS Turn-On for DAB Converter