Abstract:The backflow power in dual-active bridge (DAB) converters can cause power circulation in the H-bridge instead of flowing to the load, which increases the power loss of switching devices and magnetic components and lowers the system's efficiency. Hence, a unified optimal modulation strategy (UOMS) is proposed in this article to reduce the backflow power and consequently improve the system efficiency. However, there is a conflict between minimizing the backflow power and achieving the zero-voltage-switching (ZVS) conditions of all the switching devices. Hence, a regulatory factor " gamma" is introduced into the control variables to minimize the backflow power on the premise of all ZVS conditions, and hence, comprehensively improve the system efficiency. Moreover, the regulatory factor " gamma" simplifies the calculation form of the control variables, which is easier to perform in the controller and can effectively shorten the computational time. According to the value ranges of the control variables (D-0, D-1, and D-2) in the proposed UOMS, 12 operating modes are classified and four effective modes are detailed. For the four effective modes, the optimal triple-phase shift (TPS), optimal primary-dual-phase shift (PDPS), and optimal secondary-dual-phase shift (SDPS) modulation strategies are derived and their switching relationships are revealed. With various transferred powers, the proposed UOMS combines the optimal TPS, PDPS, SDPS, and SPS modulation strategies and can realize smooth and seamless transition switching processes among them in the full operating range. Therefore, the DAB converter can always operate in the optimal states for the full operating range of both the "Buck Mode" (k > 1) and "Boost Mode" (k < 1). Finally, experimental results verify the correctness of the theoretical analysis and the effectiveness of the proposed UOMS.

A ZVS Range Enhancement Strategy for the DAB Converter by Using Blocking Capacitors

ZVS Operation of DAB Converter Based on Triple-Phase-shift Modulation Scheme with Optimized Inductor Current

Evaluation of Capacitor Voltage Balancing Control Strategies for Multilevel DAB Converters

Towards Full Range Zero-Voltage Switching of DAB Converters: An Improved Multi-Mode Modulation at Light Loads Under Close-to-Unity Voltage Ratio

Influence of Junction-Capacitance and Dead-Time on Dual-Active-Bridge Actual Soft-Switching-Range: Analytic Analysis and Solution

Analysis and Design of a Control Strategy for Wide-Range ZVS of Isolated Bidirectional Dual-Bridge Series Resonant DC/DC Converters

Extension of Zero-Voltage Switching Region of Wide Volage Ratio Range Dual-Active-Bridge Converter by LC Antiresonant Network

A Phase Shift Control of Minimal Circulating Current and ZVS Turn-On for DAB Converter

Capacitor Voltage Balancing Control Scheme for 2/3-Level DAB Converters

Hybrid Control Strategy for an Integrated DAB–LLC–DCX DC–DC Converter to Achieve Full-Power-Range Zero-Voltage Switching

An Analog-based, Duty Cycle Modulation Method to Remove the DC Bias in the Transformer for a Dual Active Bridge Converter

Optimized Switching Strategy for ANPC–DAB Converter Through Multiple Zero States

Impact on ZVS Operation by Splitting Inductance to Both Sides of Transformer for 1-Mhz GaN Based DAB Converter

A Unified Optimal Modulation Strategy for DAB Converters to Tradeoff the Backflow Power Reduction and All ZVS in the Full Operating Range

A Model-Free Capacitor Voltage Balancing Method for Multilevel DAB Converters

Optimal Control of Multi-Level DAB Converters for Soft-Switching and Minimum Current Stress

A Unified Optimal Modulation Strategy for DAB Converters to Trade-off the Backflow Power Reduction and All ZVS in the Full Operating Range

Capacitor Voltage Balancing Control for a Novel 5-Level Dual Active Bridge Converter

Switching control strategy for full ZVS soft-switching operation of a Dual Active Bridge AC/DC converter

A Comprehensive Optimization Strategy of DAB Converter with Minimal Current Stress and Full Soft-Switching in the Whole Operating Range