Abstract:Phosphogypsum (PG) is a solid waste generated during the wet production of phosphoric acid, noted for causing significant environmental pollution due to low pH and contamination with phosphorus-fluorine impurities. This work proposes an innovative method of acid treatment to acidify PG by directly adding of sulfuric acid at suitable temperatures. Initially, this acid treatment process is employed to convert and remove phosphorus-fluorine impurities, followed by PG after acid treatment incorporation with lime for safe solidification. The conversion mechanisms of phosphorus-fluorine impurities during acidification and solidification are elucidated. Results demonstrate that the direct acidification method converts most fluoride into H 2 SiF 6 and HF, which are subsequently released from the PG system after a temperature of 175 °C treatment. Phosphorus is wholly transformed into water-soluble forms (H 3 PO 4 /H 2 PO 4 - /HPO 4 2- ), especially as eutectic phosphorus is released and converted when CaSO 4 ·2 H 2 O crystals dissolve to II-CaSO 4 . Following acidification to achieve a high water-soluble phosphorus/fluorine ratio, lime is added to convert phosphorus-fluorine impurities into Ca 5 (PO 4 ) 3 F, ensuring harmlessness. The addition of 3.7 % lime to acidified PG, an acid amount of 2-times the theoretical requirement, yields a treatment solution with pH=8.65, ρ(P)=0.05 mg/L and ρ(F - )=1.11 mg/L, meeting Class V water discharge standards (GB 3838–2002). The solidified PG filter residue contains the water–soluble ω(P 2 O 5 ) ≤ 0.01 % and ω(F - ) ≤ 0.0061 %, suitable for safe storage. This work indicates that this process can separate phosphorus impurities with lower energy consumption, providing a harmless PG treatment. Furthermore, the treated PG can hydrate to gain strength, potentially enhancing its utility as a resource.

An improved process for the purification of phosphogypsum

Treating waste phosphogypsum for cement and plaster manufacture

Investigating the novel process for thorough removal of eutectic phosphate impurities from phosphogypsum

Staged purification of phosphogypsum using pH-dependent separation process

Treatment and Purification of Phosphogypsum

Efficient precipitation of soluble phosphorus impurities in the recycling of phosphogypsum to produce hemihydrate gypsum

Novel Synergistic Process of Impurities Extraction and Phophogypsum Crystallization Control in Wet-Process Phosphoric Acid

Preparation of gypsum with high purity and whiteness from phosphogypsum for CO2 mineral sequestration

The Impurity Removal and Comprehensive Utilization of Phosphogypsum: A Review

Efficient extraction of impurities from phosphogypsum during crystal regulation of α‐hemihydrate gypsum

Gradient removal of Si and P impurities from phosphogypsum and preparation of anhydrous calcium sulfate

Flotation purification of waste high-silica phosphogypsum

Research on the technology and mechanism of direct acidification of phosphogypsum and deeply solidify impurities with lime

The Generation Process, Impurity Removal and High-Value Utilization of Phosphogypsum Material

Comparative analysis of colloid-mechanical microenvironments on the efficient purification of phosphogypsum

Efficient removal of impurities from phosphogypsum during preparation of α-hemihydrate gypsum

Influence of Impurities on the Process of Obtaining Calcium Carbonate during the Processing of Phosphogypsum

A Novel Process to Recover Gypsum from Phosphogypsum

Deep removal of phosphorus and synchronous preparation of high-strength gypsum from phosphogypsum by crystal modification in NaCl-HCl solutions