New Automatic Control System of NC Machine Tool for High Working Accuracy

M. Masuko,N. Nishiwaki,Y. Kembo,B. S. Shin

DOI: https://doi.org/10.1007/978-1-349-81544-9_19

1976-01-01

Abstract:This study deals with the development of a new system which is used to control the position of the cutting tool of a numerical control machine tool, to obtain high working accuracy. So far, high accuracy in-process sensors have been used for controlling the cutting tool, but the method followed in this new system is quite different from previous processes.In this system, after the rough cut the mark indicating the position of the finished size is put on the cutting surface of the workpiece by ultrasonic or vibration cutting. The cutting is then continued until the mark just disappears, this position being observed by the use of a simple in-process sensor. The in-process sensor is used only to detect the existence or disappearance of the mark.It is expected that by the use of this new system a dimensional accuracy can be obtained up to the order of the surface roughness.