CONTROL SYSTEM OF NC MACHINE TOOL FOR HIGH WORKING ACCURACY

N. Nishiwaki,N. Hashiba,M. Masuko

DOI: https://doi.org/10.1016/b978-0-08-022015-4.50033-4

1978-01-01

Abstract:This study deals with the development of a new system which is used to control the position of the cutting tool of a numerical control machine tool, to obtain high working accuracy and fine finished surface. So far, high accuracy in-process sensors have been only used for controlling the cutting tool, but the method followed in this new system is quite different from previous processes.In this system, after the rough cut the mark indicating the position of the finished size is put on the cutting surface of the workpiece by ultrasonic or vibration cutting. The cutting is then continued until the mark just disappears, this position being observed by the use of a simple in-process sensor. In this investigation the optical fiber installed inside the shank of the cutting tool is used as the in-process sensor. This in-process sensor can be used to detect not only the mark but also the finished surface roughness, tool wear, chattering or faulty material, because the finished surface is always optically scanned by this in-process sensor.It is expected that by the use of this system a dimensional accuracy can be obtained up to the order of the surface roughness and the finishing can be always carried out with a good surface condition.