Abstract:In situ observation and measurement of the high-temperature deformation of advanced hot-section materials using scanning electron microscopy (SEM) is beneficial for understanding their microscopic failure mechanisms. Through in-situ measurement and subsequent analysis, crack nucleation site, growth rate and propagation behavior can be determined as well as the interaction between crack and microstructure, such as inclusion, pore or grain boundary. However, these measurements are challenging above 700 degrees C as the SEM images are severely degraded by the thermal electron emission. In this work, an in situ mechanical testing system for extremely high temperatures (up to 1000 degrees C) inside an SEM was developed and used to investigate the small fatigue crack growth behavior of a nickel-based single-crystal superalloy from room temperature to 980 degrees C. The fatigue crack propagation modes and growth rates were investigated at different temperatures. The mechanism of the propagation mode transition was discussed in detail. Conventional Paris law was found no longer capable of characterizing the growth behavior of small crack. Subsequently, with the help of the digital image correlation technique, plastic zone size of the crack tip was obtained, and it was found that it could characterize the growth behavior of the small crack.

In-situ SEM study of slip-controlled short-crack growth in single-crystal nickel superalloy

In-situ fatigue behavior study of a nickel-based single-crystal superalloy with different orientations

Fatigue Fracture Mechanism of a Nickel-Based Single Crystal Superalloy with Partially Recrystallized Grains at 550 C by In Situ SEM Studies

Crystallographic analysis for fatigue small crack growth behaviors of a nickel-based single crystal by in situ SEM observation

In Situ Scanning Electron Microscopy Analysis of Effect of Temperature on Small Fatigue Crack Growth Behavior of Nickel-Based Single-Crystal Superalloy

In-situ SEM study on fatigue crack behavior of a nickel-based single crystal alloy at 950 °C and 1050 °C

In-situ Observations of the Effects of Orientation and Carbide on Low Cycle Fatigue Crack Propagation in a Single Crystal Superalloy

Micro-strain and cyclic slip accumulation in a polycrystalline nickel-based superalloy

High temperature in-situ SEM observation and crystal plasticity simulation on fretting fatigue of Ni-based single crystal superalloys

In Situ SEM Study of Creep Deformation Behavior of Nickel-Based Single-Crystal Superalloys

Effects of secondary orientation on fatigue crack initiation in a single crystal superalloy

On the fatigue small crack behaviors of directionally solidified superalloy DZ4 by in situ SEM observations

Crystallographic analysis on small fatigue crack propagation behaviour of a nickel‐based single crystal superalloy

Creep–fatigue Interaction Behavior of Nickel-Based Single Crystal Superalloy at High Temperature by In-Situ SEM Observation

Anisotropic Thermomechanical Fatigue of a Nickel-Base Single-Crystal Superalloy Part I: Effects of Crystal Orientations and Damage Mechanisms

In-situ scanning electron microscopy studies of small fatigue crack growth in recrystallized layer of a directionally solidified superalloy

Near-threshold fatigue crack propagation in a Ni-based single crystal superalloy affected by crystallographic anisotropy

In-Situ Sem Observation and Crystal Plasticity Finite Element Simulation of Fretting Fatigue Crack Formation in Ni-Base Single-Crystal Superalloys

Influence of orientation and temperature on the fatigue crack growth of a nickel-based directionally solidified superalloy

Crystallographic evaluation of low cycle fatigue crack growth in a polycrystalline Ni based superalloy

On the Fatigue Short Crack Behaviors of Directionally Solidified Superalloy Dz4 by in Situ Sem Observations