Abstract:With the widespread application and diversified demands of micro electro mechanical systems(MEMS),it is difficult to meet the design requirements of non-standard for the current design method of structure combination in the parametric elements library.Therefore,a method of mapping extraction and equivalent approximation of multi-granularity macro-model which supports non-standard structure design is presented.In the MEMS design level and flow of multi-granularity macro-modeling,the global matrix which describes the system is extracted through association and combination of nodes of complete finite element model of the MEMS device.The precise system model based on the low-order ordinary differential equations is then achieved.The large-scale sparse symmetric matrix is saved via one-dimensional variable bandwidth storage.The equivalent approximation model is obtained by Lagrange polynomial fitting and generalized minimal residuals.The fidelity relationships between the input and output of the system of the non-standard structure are built to connect the models of connector level and system level.The product continuous is finally realized via design iteration.The independent prototype system using ACIS as geometry modeling kernel is developed to verify the proposed method by a digital light procession micro-mirror.The test results prove that the present design ability is extended from limited simple devices in element library to the complex,strange,non-standard structure.It has important significance to improve efficiency and quality of the design of MEMS.

Application of modified Arnoldi algorithm to passive macromodeling of MEMS

Advanced Computational-Time Reduction Technology of Nonlinear Fourier-Based and Magnetic Circuit Hybrid Model

Design Method of Non-standard Structure for MEMS Based on Multi-granularity Macro-modeling

Macromodel extraction for MEMS devices based on model order reduction

Research Status of Macro-Modeling of MEMS Devices for Systems Level Simulations

Macromodeling of the electrostatically actuated circular plate based on mode superposition method

Macromodeling Of The Electrostatically Actuated Rectangle Plate Based On Modal Projection

Passive Reduced-Order Macromodeling Algorithm for Microelectromechanical Systems

Genetic Algorithm for Electro-Mechanical Co-Optimization of a MEMS Accelerometer Comprising a Mechanical Motion Pre-Amplifier with a 2Nd-Order Sigma Delta Modulator

A Mems Electro-Mechanical Co-Optimization Platform Featuring Freeform Geometry Optimization Based on a Genetic Algorithm

A Block Arnoldi Algorithm Based Reduced-Order Model Applied to Large-Scale Algebraic Equations of a 3-D Field Problem

GENETIC ALGORITHM FOR THE DESIGN OF FREEFORM GEOMETRIES IN A MEMS ACCELEROMETER COMPRISING A MECHANICAL MOTION PRE-AMPLIFIER

Investigation of a Complete Squeeze-Film Damping Model for MEMS Devices

A New Modeling Method of MEMS System's Noise

Efficient And Memory Saving Method Based On Pseudoskeleton Approximation For Analysis Of Finite Periodic Structures

A Novel High-Speed and High-Accuracy Mathematical Modeling Method of Complex MEMS Resonator Structures Based on the Multilayer Perceptron Neural Network

Macromodeling method of fluid-structure interacting mems based on modal analysis and proper orthogonal decomposition

An Efficient Macromodel Extraction Strategy for Packaged MEMS Thermal Wind Sensor Considering Multiphysics

Reduced Order Modeling of Dynamic Mechanical Metamaterials for Analysis of Infinite and Finite Systems

Development of a reduced-order AROMM model for the nonlinear thermal simulation of electronic components

Efficient design and optimization of MEMS by integrating commercial simulation tools