Abstract:The transducer is an essential part of all ultrasonic systems used for applications such as medical diagnostics, therapy, nondestructive evaluation, and cleaning because its health condition is vital to their proper operation. Defects within the active element, backing or other constitutive elements, and loss of adhesion between layers can significantly weaken the performance of a transducer. The objective of this work is to determine procedures to monitor the behavior of a single-element probe during its lifetime and detect degradations before they significantly affect the performance of the system. To achieve this, electromechanical admittance (EMA)-based method is envisaged numerically and experimentally. A simplified single-element transducer consisting of a piezoceramic disk, a bonding layer, and a backing is studied and the influence of bonding delamination on EMA is investigated. This study considers three different types of delaminations, which are named, respectively, "center" (circular delamination from the center of the disk toward the peripheric zone), "peripheric" (annular delamination from the peripheric zone toward the center), and "wedge" (wedge-shaped delamination with a given angle). For each case, a numerical model based on the finite-element (FE) method is developed: a 2-D FE analysis is implemented for the first two types of delaminations, taking advantage of their axisymmetric structure, and "wedge" delamination is modeled in 3-D. Then, transducers with different shapes of 3-D printed backings are mounted and experiments are conducted using an impedance analyzer. Finally, experimental results are found to be in good agreement with numerical solutions and it shows that changes in EMA can particularly reveal the occurrence and extent of delamination in an ultrasound probe.

Dielectric antenna effects in integrating line piezoelectric sensors for optoacoustic imaging

Nonlinear Dielectric Response in Piezoelectric Materials for Underwater Transducers

Ultrawideband sub-pascal sensitivity piezopolymer detectors

Micromachined piezoelectric sensor with radial polarization for enhancing underwater acoustic measurement

3D-Printable Piezoelectric Composite Sensors for Acoustically Adapted Guided Ultrasonic Wave Detection

Health Monitoring of Single-Element Piezoelectric Transducer Using Its Electromechanical Admittance

Mechanical Strain, Temperature, and Misalignment Effects on Data Communication between Piezoceramic Ultrasonic Transducers

Package-less liquid phase sensing using surface acoustic waves on lithium tantalate oxide

Piezoelectric transducer design and impedance tuning for concurrent ultrasonic power and data transfer

Characterization of a Piezoelectric Acoustic Sensor Fabricated for Low-Frequency Applications: A Comparative Study of Three Methods

Polymer Microring Resonators for High Sensitivity, Broadband, Wide-Directivity Ultrasound Detection and High-Resolution Imaging

Dielectric and Electroacoustic Assessment of Screen-printed Piezoelectric Polymer Layers As Flexible Transducers: Influence of the Electrode Material

Transparent Flexible Piezoelectric Ultrasound Transducer for Photoacoustic Imaging System

Textured Ferroelectric Ceramics Based 1–3 Piezoelectric Composite for Photoacoustic Imaging

Acoustic Metamaterial Antennas for Combined Highly Directive-Sensitive Detection

New Solid-State Acoustic Motion Sensors: Sensing Potential Estimation for Different Piezo Plate Materials

A PDMS-based broadband acoustic impedance matched material for underwater applications

Advances in Piezoelectric Thin Films for Acoustic Biosensors, Acoustofluidics and Lab-on-chip Applications

Ultrabroad Bandwidth and Highly Sensitive Optical Ultrasonic Detector for Photoacoustic Imaging

Unveiling Acoustic Cavitation Characterization in Opaque Chambers through a Low-Cost Piezoelectric Sensor Approach

Fabrication and modeling of piezoelectric transducers for High-Frequency medical imaging