Abstract:The elastic properties of 1D nanostructures such as nanowires are often measured experimentally through actuation of the nanowire at its resonance frequency, and then relating the resonance frequency to the elastic stiffness using elementary beam theory. In the present work, we utilize large scale molecular dynamics simulations to report a novel beat phenomenon in [110] oriented Ag nanowires. The beat phenomenon is found to arise from the asymmetry of the lattice spacing in the orthogonal elementary directions of the [110] nanowire,i.e., [-110] and [001] directions, which results in two different principal moments of inertia. Because of this, actuations imposed along any other direction are found to decompose into two orthogonal vibrational components based on the actuation angle relative to these two elementary directions, with this phenomenon being generalizable to <110> FCC nanowires of different materials (Cu, Au, Ni, Pd and Pt).The beat phenomenon is explained using a discrete moment of inertia model based on the hard sphere assumption, the model is utilized to show that surface effects enhance the beat phenomenon, while the effect is reduced with increasing nanowires cross-sectional size or aspect ratio.Most importantly, due to the existence of the beat phenomena, we demonstrate that in resonance experiments only a single frequency component is expected to be observed, particularly when the damping ratio is relatively large or very small.Furthermore, for a large range of actuation angles, the lower frequency is more likely to be detected than the higher one,which implies the experimental predictions of Young's modulus obtained from resonance may in fact be under predictions. The present study therefore has significant implications for experimental interpretations of Young's modulus as obtained via resonance testing.

Time-Resolved Open-Circuit Conductive Atomic Force Microscopy for Quantitative Analysis of Nanowire Piezoelectricity and Triboelectricity

Beat Phenomena in Metal Nanowires, and Their Implications for Resonance-Based Elastic Property Measurements.

High-precision Strategy for Piezoelectric Characterization of Nano/ Microwire

J212015 Quantitative Evaluation of Conductivity of Metallic Nanowires by Microwave Atomic Force Microscopy

In situ electron microscopy four-point electromechanical characterization of freestanding metallic and semiconducting nanowires

Investigation of the diameter-dependent piezoelectric response of semiconducting ZnO nanowires by Piezoresponse Force Microscopy and FEM simulations

Piezo-generated charge mapping revealed through Direct Piezoelectric Force Microscopy

Measurement and Simulation of Carbon Nanotube'S Piezoresistance Property by A Micro/Nano Combined Structure

Electrical Actuation and Readout in a Nanoelectromechanical Resonator Based on a Laterally Suspended Zinc Oxide Nanowire

A Method Based on Optical and Atomic Force Microscopes for Instant Imaging of Non-Homogeneous Electro-Mechanical Processes and Direct Estimation of Dij Coefficients in Piezoelectric Materials at the Local Level

Non-contact Local Conductivity Measurement of Metallic Nanowires Based on Semi-Near-field Reflection of Microwave Atomic Force Microscopy

Accurate 3D Nanoscale Electromechanical Imaging with a Metrological Atomic Force Microscope

A novel approach for piezoresistivity characterization of silicon nanowires

In situ observation of current generation in ZnO nanowire based nanogenerators using a CAFM integrated into an SEM.

Quantitative Electromechanical Atomic Force Microscopy

In Situ Quantification of Strain‐Induced Piezoelectric Potential of Dynamically Bending ZnO Microwires

Fast and direct visualization of piezo-generated charges at the nanoscale using direct piezoelectric force microscopy

Resetting Piezoresponse Force Microscopy: Towards a real quantitative technique

Piezoresponse Force Microscopy on Doubly Clamped KNbO3 Nanowires

Atomistic-Benchmarking towards a protocol development for rapid quantitative metrology of piezoelectric biomolecular materials

Fabrication and Characterization of Piezoelectric Cantilever Array with Nano-Assembly Carbon Nanotube Tips