Abstract:Abstract This paper presents 3D Fabry–Pérot (FP) cavities fabricated directly onto cleaved ends of low-loss optical fibers by a two-photon polymerization (2PP) process. This fabrication technique is quick, simple, and inexpensive compared to planar microfabrication processes, which enables rapid prototyping and the ability to adapt to new requirements. These devices also utilize true 3D design freedom, facilitating the realization of microscale optical elements with challenging geometries. Three different device types were fabricated and evaluated: an unreleased single-cavity device, a released dual-cavity device, and a released hemispherical mirror dual-cavity device. Each iteration improved the quality of the FP cavity’s reflection spectrum. The unreleased device demonstrated an extinction ratio around 1.90, the released device achieved 61, and the hemispherical device achieved 253, providing a strong signal to observe changes in the free spectral range of the device’s reflection response. The reflectance of the photopolymer was also estimated to be between 0.2 and 0.3 over the spectrum of interest. The dual-cavity devices include both an open cavity, which can interact with an interstitial medium, and a second solid cavity, which provides a static reference reflection. The hemispherical dual-cavity device further improves the quality of the reflection signal with a more consistent resonance, and reduced sensitivity to misalignment. These advanced features, which are very challenging to realize with traditional planar microfabrication techniques, are fabricated in a single patterning step. The usability of these FP cavities as thermal radiation sensors with excellent linear response and sensitivity over a broad range of temperature is reported. The 3D structuring capability the 2PP process has enabled the creation of a suspended FP heat sensor that exhibited linear response over the temperature range of 20 oC –120 oC; temperature sensitivity of ∼50 pm oC −1 at around 1550 nm wavelength; and sensitivity improvement of better than 9x of the solidly-mounted sensors.

Tests of cryogenic Fabry-Perot cavity with mirrors on different substrates

Measuring the Refractive Index of Optical Adhesives at Cryogenic Temperatures.

Fabrication of Optical Cavities with Femtosecond Laser Pulses

Towards a sub-kelvin cryogenic Fabry-Perot silicon cavity

Fabry-Pérot open resonant cavities for measuring the dielectric parameters of mm-wave optical materials

R&D Towards Cryogenic Optical Links

Inexpensive optical fiber Fabry–Perot microcavity with controllable length for sensitive temperature measurements

Ultrastable lasers: investigations of crystalline mirrors and closed cycle cooling at 124 K

Experimental Study of the Free Spectral Range (FSR) in FPI with a Small Plate Gap

Comparison of Measurements with Finite-Element Analysis of Silicon-Diaphragm-Based Fiber-Optic Fabry–Perot Temperature Sensors

Diffractively coupled Fabry-Perot resonator with power-recycling

Multiplexed fiber-optic Fabry-Pérot cavities for refractive index and temperature sensing fabricated using diamond-blade dicing

Three-dimensional Fabry–Pérot cavities sculpted on fiber tips using a multiphoton polymerization process

A mechanically stable and tunable cryogenic Fabry-Perot microcavity

Temperature Sensor Cascading Reflective Fabry-Perot Cavity with Microring Resonator

Optical Properties of Direct Wafer Bonded Micro-Cavity Structures

Fabrication and Analysis of a Fabry-Perot Cavity with a Micromechanical Wet-Etching Process.

Optimizing the Efficiency of Fabry-Perot Interferometers with Silicon-Substrate Mirrors

A highly stable and fully tunable open microcavity platform at cryogenic temperatures

Photothermal and thermo-refractive effects in high reflectivity mirrors at room and cryogenic temperature

Ultrastable vacuum-gap Fabry-Pérot cavities operated in air