Abstract:An acoustic field distribution investigation in air requires a small receiving sensor. Needle hydrophones seem to be an attractive solution, and it has previously been demonstrated that needle hydrophones designed for use in water can be used in air. The metrology problem is that an absolute sensitivity calibration is needed, because needle hydrophones are not characterized in air, especially for frequencies below 1 MHz, which is of interest for air-coupled ultrasound. Conventional, three-transducer/microphone reciprocity calibration requires measurements to be done in the far field. However, when transducer diameter is large and the frequency is high, the required measurement distance becomes very large: 3 m for a 20 mm source, transmitting at 1 MHz. Large propagation distance leads to high attenuation and nonlinear effects in air propagation, and distortion and losses accumulate. Small needle hydrophones have low sensitivity, so that high excitation amplitudes would be required, which can lead to transducer heating and increase nonlinearity effects. A derivative of the three-transducer reciprocity calibration method is proposed, where a large aperture transducer is focused onto a hydrophone, using hybrid of plane wave and spherical wave reciprocity. Use of a focused source minimizes the frequency-dependent diffraction effects, and the spherical wave approximation is valid at the focal distance, and low level excitation signals can be used. Focusing is accomplished using a parabolic off-axis mirror. Calibration is in transmission, which reduces the complexity of the electrical measurements. The corresponding equations have been derived for this setup. Calibration of the transducer and needle hydrophone absolute sensitivity is obtained.

Reciprocity calibration of impulse responses of acoustic emission transducers

Modelling of Reciprocal Transducer System Accounting for Nonlinear Constitutive Relations

New concept of transient calibration for acoustic transducers

The Calibration Methods of Hydrophones for Underwater Environmental Sound Measurements or Biomedical Ultrasound Measurements: A Review

Transient Calibration of Underwater Acoustic Transducers

Magnitude and phase reciprocity calibration of ultrasonic piezoelectric disk in air

A self-reciprocity calibration of spherical transducers using boundary reflection in a spherical shell

THE CALCULATION OF RECIPROCITY PARAMETERS OF COU-PLER CALIBRATION AND THE CORRECTION OF SENSITIVITY OF CONVENTIONAL COMPUTATION

Reciprocity in laser ultrasound revisited: Is wavefield characterisation by scanning laser excitation strictly reciprocal to that by scanning laser detection?

Reciprocity in laser ultrasound revisited: Is wavefield characterization by scanning laser excitation strictly reciprocal to that by scanning laser detection?

Noncontact acousto-electromagnetic measurement of mechanical resonance in electronic systems

Estimating Lab-Quake Source Parameters: Spectral Inversion from a Calibrated Acoustic System

A measuring method for the resonant frequency of flexural horn-type transducer using non-contacting piezoelectric sensor

Transmitting Antenna's Reflected Power and Its Influence on Reverberation Chamber Calibration

Bayesian waveform-based calibration of high-pressure acoustic emission systems with ball drop measurements

Acoustic emission localization in beams based on time reversed dispersion

The Research of Optical Fiber Sensor Calibration Based on Acoustic Sensor Calibration System

Calibration Test of Reverberation Chamber

Numerical Simulation of Reverberant Acoustic Field Environment Test Based on Reciprocity Theorem

Ultrasonic needle hydrophone calibration in air by a parabolic off-axis mirror focused beam using three-transducer reciprocity

A Primary Wideband Calibration Method for Noise Hydrophones Based on Three-Transducer Spherical Wave Reciprocity in the Frequency Domain.