Abstract:An acoustic field distribution investigation in air requires a small receiving sensor. Needle hydrophones seem to be an attractive solution, and it has previously been demonstrated that needle hydrophones designed for use in water can be used in air. The metrology problem is that an absolute sensitivity calibration is needed, because needle hydrophones are not characterized in air, especially for frequencies below 1 MHz, which is of interest for air-coupled ultrasound. Conventional, three-transducer/microphone reciprocity calibration requires measurements to be done in the far field. However, when transducer diameter is large and the frequency is high, the required measurement distance becomes very large: 3 m for a 20 mm source, transmitting at 1 MHz. Large propagation distance leads to high attenuation and nonlinear effects in air propagation, and distortion and losses accumulate. Small needle hydrophones have low sensitivity, so that high excitation amplitudes would be required, which can lead to transducer heating and increase nonlinearity effects. A derivative of the three-transducer reciprocity calibration method is proposed, where a large aperture transducer is focused onto a hydrophone, using hybrid of plane wave and spherical wave reciprocity. Use of a focused source minimizes the frequency-dependent diffraction effects, and the spherical wave approximation is valid at the focal distance, and low level excitation signals can be used. Focusing is accomplished using a parabolic off-axis mirror. Calibration is in transmission, which reduces the complexity of the electrical measurements. The corresponding equations have been derived for this setup. Calibration of the transducer and needle hydrophone absolute sensitivity is obtained.

New concept of transient calibration for acoustic transducers

Transient Calibration of Underwater Acoustic Transducers

The Calibration Methods of Hydrophones for Underwater Environmental Sound Measurements or Biomedical Ultrasound Measurements: A Review

Measurement of acoustic properties for passive-material samples using multichannel inverse filter.

Experimental Study on Measuring Reflection Coefficients at Oblique Incidence Using the Inverse Filter

Measurement of the Echo Reduction for Passive Materials Based on Inverse Filtering Technique

Measurement of the absorption coefficient for acoustical coating samples using multi-channel inverse filter

Development Of Vibration Environment For Calibration Ultra-Low-Frequency Seismometers

Calibration of Hydrophones Using a Frequency Domain Filter Processing Method: Theory and Experiment

Study of Acoustic Tomography Based on Data Assimilation for Shallow Water Environments

Sound Transmission Loss Correction Due To Hydrophone Fluctuation With Propagation Model

A Novel Ultrasonic Transducer Module with an Own Reference Sound Channel for Flow Measurement

Reciprocity calibration of impulse responses of acoustic emission transducers

Simultaneous Thickness, Velocity, Density, and Attenuation Measurement of a Thin Layer by Time-Resolved Acoustic Microscopy

Seafloor Transponder Calibration Using Improved Perpendiculars Intersection

Calibration of an Acoustic System for Measuring 2-D Temperature Distribution Around Hydrothermal Vents.

Acoustic streaming-based calibration of ultrasound transducers

A Primary Wideband Calibration Method for Noise Hydrophones Based on Three-Transducer Spherical Wave Reciprocity in the Frequency Domain.

The Research of Optical Fiber Sensor Calibration Based on Acoustic Sensor Calibration System

An improvement scheme of broadband sound absorption measurement in water-filled impedance tube with monostatic transducer

Ultrasonic needle hydrophone calibration in air by a parabolic off-axis mirror focused beam using three-transducer reciprocity