Abstract:In this paper the problem of boundary control of vibration in a clamped-free strain gradient Timoshenko micro-cantilever is studied. For getting systems closer to reality, the force or moment exertion conditions should be modeled. To this end, a piezoelectric layer is laminated on one side of the beam and the controlling actuation is applied through the piezoelectric voltage. The beam and piezoelectric layer are coupled and modeled at the same time and the dynamic equations and boundary conditions of the system are achieved using the Hamilton principle. To achieve the purpose of eliminating vibration of the system, the control law is obtained from a Lyapunov function using Lasalle invariant set theorem. The control law has a form of feedback from the spatial derivatives of boundary states of the beam. The finite element method using the strain gradient Timoshenko beam element has been used and then the simulation is performed to illustrate the impact of the proposed controller to the micro beam.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the vibration control problem of the strain - gradient Timoshenko micro - cantilever beam with piezoelectric actuators under clamped - free boundary conditions. Specifically, the authors focus on how to effectively suppress the vibration of the system by pasting a layer of piezoelectric material on one side of the beam and applying piezoelectric voltage.
### Core of the problem
1. **Model establishment**: In order to make the model closer to the actual situation, the action conditions of force / torque need to be considered. For this purpose, a layer of piezoelectric material is pasted on one side of the beam and controlled by piezoelectric voltage.
2. **Dynamic equations and boundary conditions**: The partial differential equations (PDE) of the system and their boundary conditions are derived by using Hamilton's principle.
3. **Control law design**: Based on Lyapunov function and LaSalle's invariance principle, a feedback control law is designed to eliminate the vibration of the system. This control law depends on the spatial derivatives of the beam boundary state.
4. **Finite element method modeling and simulation**: The strain - gradient Timoshenko beam element is used for finite - element modeling, and the effect of the designed controller is verified by numerical simulation.
### Main steps
1. **Dynamics modeling**:
- The partial differential equations and boundary conditions of the system including piezoelectric effect are derived by using Hamilton's principle.
- The formula is expressed as:
\[
\int_{t_0}^{t} (\delta T + \delta W^* - \delta W_m + \delta W_{nc}) dt = 0
\]
where \(T\) is kinetic energy, \(W^*\) is co - energy, \(W_m\) is magnetic potential energy, and \(W_{nc}\) is the work done by non - conservative forces.
2. **Control law design**:
- Based on Lyapunov stability theory and LaSalle's invariance principle, the boundary control law is designed.
- The form of the control law is:
\[
u(t) = k_u \alpha_t(L)
\]
where \(k_u\) is the controller gain, and \(\alpha_t(L)\) is the time derivative of the rotation speed of the beam at the free end.
3. **Finite element method**:
- The system is modeled by using the finite element method to obtain the mass matrix, stiffness matrix and force matrix.
- The motion equation is numerically solved:
\[
[M]\{\ddot{q}\} + [K]\{q\} = \{F\}
\]
4. **Simulation verification**:
- The system responses before and after control are shown by simulation, and the effectiveness of the controller is verified.
### Conclusion
Through the above methods, the authors successfully designed and verified an effective boundary controller, which can significantly suppress the vibration of the micro - cantilever beam. This research result is not only of great theoretical significance, but also has potential value in practical applications, such as vibration control in MEMS and NEMS fields.