Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Active Control on Coupled Bending-Torsion Vibration of Two-Link Space Flexible Component

Active Torsional Vibration Control of Flexible Manipulator

Variable Structure Control Coupled Bending-torsional Flexible Structure System

Active control of bending-torsion-coupled vibration of a space flexible manipulator

Active Vibration Control of Flexible Structures with Super-Coiled Actuators

DYNAMIC CONTROL OF TENSION STRUCTURES

Nonlinear active control of tensegrity structures

Dynamics of a Rotating Flexible Multi-Link with Viscoelastic Constraining Layers

Active vibration control of a flexible beam based on experimental modal analysis

Decoupled Dynamic Model and Control of Flexible Space Manipulator

Dynamic Modeling and Vibration Control of a Space Flexible Manipulator Using Piezoelectric Actuators and Sensors

Non-linear joint dynamics and controls of jointed flexible structures with active and viscoelastic joint actuators

Bending/Torsion Control of Wing Panels With Diagonal X-Actuators

Multiflexoelectric Actuation and Control of Beams

Adaptive modal vibration control for smart flexible beam with two piezoelectric actuators by multivariable self-tuning control

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

Dynamics and Distributed Vibration Controls of Flexible Manipulators; Integrated Distributed Sensing and Active Piezoelectric Actuator

Distributed Structural Dynamics Control of Flexible Manipulators—ii. Distributed Sensor and Active Electromechanical Actuator

Dynamic Flexoelectric Actuation and Vibration Control of Beams

A New X-Actuator Design for Controlling Wing Bending and Twisting Modes