Abstract:Signal to noise ratios (SNR) in magnetic resonance microscopy images are limited by acquisition times and the decreasing number of spins in smaller voxels. Significant SNR gains from cooling of the RF receiver are only realized when the Johnson noise generated within the RF hardware is large compared to the electromagnetic noise produced by the sample. Cryogenic cooling of imaging probes is common in high field systems but proves difficult to insulate the sample from extreme temperatures. We designed a chamber to cool only the tune and match circuitry to show it is possible to achieve much of the available SNR gain available for cooled coils. We designed a microcoil circuit to resonate at 650 MHz for imaging on a 15.2 T scanner. Surface loops and solenoids of varying diameters were tested to determine the largest diameter coil that demonstrated significant SNR gains from cooling. A liquid N2 cryochamber was designed to cool the circuitry while leaving the RF coil in ambient air. As the cryochamber was filled with liquid N2, Q-factors were measured on the bench while monitoring the coil's surface temperature. Improvements of SNR on images of solutions were demonstrated via cooling the tune and match circuit in the magnet bore. At 650 MHz, loops and solenoids < 3 mm in diameter showed significant improvements in quality factor on the bench. The resistance of the variable capacitors and the coaxial cable were measured to be 45% and 32% of room temperature values near the Larmor frequency. Images obtained with a 2 turn, 3 mm diameter loop with the matching circuit at room temperature and then cooled with liquid nitrogen demonstrated SNR improvements of a factor of 2. By cooling the tune and match circuit and leaving the surface loop in ambient air, SNR was improved by a factor of 2. The results are significant because it allows for more space to insulate the sample from extreme temperatures.

Vibration isolation with high thermal conductance for a cryogen-free dilution refrigerator

A 10 mK hermetic cell for eliminating parasitic heating in cryogen-free dilution refrigerators

Characterization of Two Fast-Turnaround Dry Dilution Refrigerators for Scanning Probe Microscopy

Isolation solution for extreme environmental vibrations for quantum-enabling cryogenic setups installed on raised frames

Performance benchmarking of an ultra-low vibration laboratory to host a commercial millikelvin scanning tunnelling microscope

Design of a scanning gate microscope in a cryogen-free dilution refrigerator

Vibration decoupling system for massive bolometers in dry cryostats

Development of a cryogen-free dilution refrigerator

Vibration-induced electrical noise in a cryogen-free dilution refrigerator: characterization, mitigation, and impact on qubit coherence

A compact ultrahigh vacuum scanning tunneling microscope with dilution refrigeration

Torsional Oscillator for Internal-Friction Data at 100-Khz

Low-vibration cryogenic test facility for next generation of ground-based gravitational-wave observatories

Scanning SQUID microscopy in a cryogen-free dilution refrigerator

Atomic resolution STM in a cryogen free dilution refrigerator at 15 mK

A Cryogenic Tune and Match Circuit for Magnetic Resonance Microscopy at 15.2T

Development of a cryogen-free sub-3 K low-temperature scanning probe microscope by remote liquefaction scheme

Versatile Millikelvin Hybrid Cooling Platform for Superconductivity Research

Cryogenic Microwave Filter Cavity with a Tunability Greater than 5 GHz

Thermal coupling of silicon oscillators in cryogen-free dilution refrigerators

Closed-cycle, low-vibration 4 K cryostat for ion traps and other applications