Optical power meter using radiation pressure measurement

Patrick Pinot,Zaccaria Silvestri

DOI: https://doi.org/10.1016/j.measurement.2018.07.087

2018-07-02

Abstract:This paper describes a radiation pressure meter based on a diamagnetic spring. We take advantage of the diamagnetic property of pyrolytic carbon to make an elementary levitated system. It is equivalent to a torsional spring-mass-damper system consisting of a small pyrolytic carbon disc levitated above a permanent magnet array. There are several possible measurement modes. In this paper, only the angular response to an optical power single-step is described. An optical detection composed of a laser diode, a mirror and a position sensitive detector (PSD) allow measurement of the angular deflection proportional to the voltage delivered by the PSD. Once the parameters of the levitated system depending on its geometrical and physical characteristics have been determined regardless of any optical power, by applying a simple physical law, one can deduce the value of the optical power to be measured from the measurement of the first maximum of the output voltage amplitude.

Applied Physics,Instrumentation and Detectors

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to develop an optical power meter based on radiation pressure measurement, and utilize the strong diamagnetism of pyrolytic carbon (PyC) to achieve a six - degree - of - freedom stable levitation system. Specifically, the author proposes a radiometer based on a pyrolytic carbon levitation system to detect the torque provided by the laser beam, thereby measuring the optical power. The main objective of the research is to provide a new, high - precision measurement method in the optical power range from 100 mW to 1 W.

### Main Problems and Background

1. **Limitations of Existing Technologies**:
- **Photoelectric Sensors**: Suitable for high - power measurement, but it is necessary to know the small - proportion splitting ratio, and they are sensitive to temperature and optical power distribution.
- **Thermopile Sensors**: Can directly measure high power, but have a slow response and require the entire laser power to be irradiated onto the power meter.

2. **Advantages of the New Method**:
- **Non - Absorptive Measurement**: By detecting radiation pressure, the heat influence brought by absorptive materials is avoided.
- **High Precision**: Utilize the strong diamagnetism of pyrolytic carbon to achieve stable levitation and improve measurement precision.
- **Wide Measurement Range**: Applicable to the optical power range from 100 mW to 1 W.

### Research Content

1. **Theoretical Principles**:
- **Radiation Pressure**: The formula for radiation pressure is derived, taking into account the influence of reflectivity and incident angle.
- **Magnetic Levitation System**: The levitation mechanism of the pyrolytic carbon disk on the permanent magnet array is described in detail, including the magnetic force gradient and stability conditions.

2. **Experimental Setup**:
- **Levitation System**: Use a pyrolytic carbon disk and a permanent magnet array to achieve six - degree - of - freedom stable levitation.
- **Optical Detection**: Measure the angular deflection of the levitation system through a laser diode, a mirror and a position - sensitive detector (PSD), and then calculate the optical power.

3. **Theoretical Calculation**:
- **Spring Constant**: Calculate the spring constants in the vertical direction and in - plane.
- **Resonance Frequency**: Analyze the resonance frequency and damping characteristics of the system.
- **Sensitivity**: Derive the sensitivity formula of the system and conduct an uncertainty analysis.

4. **Preliminary Results**:
- **Voltage Response**: Show the PSD voltage response curves under different optical powers, verifying the feasibility and precision of the system.

### Conclusion

This research proposes a new - type optical power meter based on a pyrolytic carbon levitation system, which measures optical power by detecting radiation pressure. The experimental results show that this method has high measurement precision and stability in the power range from 100 mW to 1 W, providing a new solution for optical power measurement.