Abstract:In the present study, we analyse the mechanical structure for the two-stage anvil cell, and design the two-stage high pressure cell using diamond-cemented carbide compound as anvil-material. The diamond-cemented carbide compound material is synthesized using the 6 × 2500 ton cubic press in our laboratory. We sinter diamond/Co layer (Φ30 mm×10 mm) on a WC-cobalt substrate (Φ30 mm×13 mm) at high pressures and temperatures, then, we obtain the cubic anvils from the sintered cylindrical chunks by wire-electrode cutting. The diamond-cemented carbide compound anvil has three advantages over the traditional sintered diamond anvil:first, a scaled-up version of the sintered diamond anvil could be obtained by sintering the diamond/Co layer on a WC-cobalt substrate;second, the diamond-cemented carbide compound anvil is machined easily compared with the sintered diamond anvil;and third, the experimental cost using the diamond-cemented carbide compound anvils is much lower than using the sintered diamond anvil. Using the diamond-cemented carbide compound anvil, we design the two-stage 5.5/1.5 (octahedral edge-length/anvil truncation edge-length, in millimetre) assemble. Pressure calibration at room temperature is performed for the 5.5/1.5 assemble using the phase transitions of Zr (α-ω, 7.96 GPa;ω-β, 34.5 GPa) under high pressures. The pressure range of the two-stage apparatus besed on hinge-type cubic press is extended from 20 GPa to about 35 GPa using the 5.5/1.5 assemble. The pressure calibration for the two-stage apparatus using diamond-cemented carbide compound anvil is ongoing in our laboratory. We believe that the pressures above 50 GPa could be achieved using these anvils.

Diamond anvil cell using boron-doped diamond electrodes covered with undoped diamond insulating layer

Diamond anvil cell with boron-doped diamond heater for high-pressure synthesis and in-situ transport measurements

Calibration of Pressure to 35 Gpa for the Cubic Press Using the Diamond-Cemented Carbide Compound Anvil

High-pressure synthesis of superconducting Sn$_{3}$S$_{4}$ using diamond anvil cell with boron-doped diamond heater

High Pressure High Temperature Synthesis of Highly Boron Doped Diamond Microparticles and Porous Electrodes for Electrochemical Applications

A diamond anvil microassembly for Joule heating and electrical measurements up to 150 GPa and 4000 K

In-Situ Conductivity Measurement of BaF 2 under High Pressure and High Temperature

Generation Of Ultrahigh Pressure Using Single-Crystal Chemical-Vapor-Deposition Diamond Anvils

Patterned Diamond Anvils Prepared Via Laser Writing for Electrical Transport Measurements of Thin Quantum Materials under Pressure

A Diamond Gasket for the Laser-Heated Diamond Anvil Cell

A nano-polycrystalline diamond anvil cell with bulk metallic glass cylinder for single-crystal neutron diffraction

Effect of B-S co-doping on large diamonds synthesis under high pressure and high temperature

Amorphous Boron Gasket in Diamond Anvil Cell Research

Diamond Anvil Cell Behavior Up to 4 Mbar

Composite Chemical Vapor Deposition Diamond Anvils for High-Pressure/high-temperature Experiments

Studies on Synthesis and Growth Mechanism of High Quality Sheet Cubic Diamond Crystals under High Pressure and High Temperature Conditions

New Methods for Investigating Superconductivity at Very High Pressures

Synthesis of N-type semiconductor diamonds with sulfur, boron co-doping in FeNiMnCo-C system at high pressure and high temperature

Study on Synthesis and Electrical Properties of Slab Shape Diamond Crystals in FeNiMnCo-C-P System under HPHT

Recent Design of Ultrahigh-Pressure Diamond Cell