Abstract:PLL frequency synthesizers with low jitter are essential for mm-Wave high-speed wireless communication systems and data converters. By doing away with the frequency doubler, low jitter synthesizers with the 2 ND harmonic output can simplify their architecture. Additionally, to produce high-quality local oscillator signals for 2ND harmonic output, it is beneficial to suppress the fundamental frequency component at 2 ND harmonic output. In general, lowering the voltagecontrolled oscillator's phase noise (PN) and reducing the PLL's bandwidth to suppress in-band noise are the two most popular ways to minimize PN of PLL. The phase noise of N-core VCO reduce PN by 10logN, which is an effective method for obtaining low PN. Additionally, increasing the reference clock frequency hence decreasing the loop frequency division ratio can decrease PN. Literature [1] used a reference clock frequency of 500MHz with 175mW to implement the PLL of 52-fs <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">rms</inf> Jitter. Ref. [2] adopted a folded transformer-based series resonance CMOS VCO, the PN of which achieved -130.8dBc/Hz@1MHz, consumed 242mW while reducing the core area. Ref. [3] uses a clock frequency of 250MHz to reduce the overall contribution of VCO through wideband PLL, while suppressing the noise introduced by the reference clock through the design of double-sampling phase detector (SPD). Ref. [4] uses the high gain of phase-frequency detector (PFD) with time amplification to suppress the gain of CP, thus achieving the performance of 60-fs <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">rms</inf> Jitter. This study presents the construction of a PLL based on a 4-core resistance-synchronized VCO that achieves 47-fs <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">rms</inf> Jitter and produces 2 ND harmonic with fundamental frequency suppression.

PLL jitter reduction by utilizing a ferroelectric capacitor as a VCO timing element

Optimized System Design for Fully Integrated Fractional-N Pll

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A 0.8 V Low Power Low Phase-Noise Pll

A 40 Ghz 65 Nm Cmos Phase-Locked Loop with Optimized Shunt-Peaked Buffer

A Low-Jitter and Low-Reference-Spur Ring-VCO-Based Switched-Loop Filter PLL Using a Fast Phase-Error Correction Technique

A Sub-ps Integrated-Jitter 10 GHz ADPLL with Fractional Capacitor

A 56-GHz Fractional-N PLL With 110-fs Jitter

A 37.2-Fs, -254.6-db FoM, 47.9-to-56.4 GHz PLL Using Tightly Coupled Dual-core VCO with Implicit 4th Harmonic Extraction Technique

Emergent Ferroelectric Switching Behavior from Polar Vortex Lattice

14.7 A 0.45V 0.72mw 2.4ghz Bias-Current-Free Fractional-N Hybrid PLL Using a Voltage-Mode Phase Interpolator in 28nm CMOS

IEEE ASSCC 2023/ Session 10/ Paper 10.5.

A Low-Power RF CMOS Charge Pump PLL

Toward a GHz-Frequency BEOL Ferroelectric Negative-Capacitance Oscillator With a Wide Tuning Range

Effects of Fringing Capacitor on Ferroelectric Phase Shifter

A Low-Voltage Bias-Current-Free Pseudo-Differential Hybrid PLL Using a Time-Interleaving Flip-Flop Phase Detector

A 28.8-to-43.2 GHz 79.8 fs$_{\mathrm{rms}}$ Jitter and $-$78.5 dBc Reference Spur PLL Exploiting Complementary Mixing Phase Detector With Mismatch Calibration

A 0.022mm2 970µw Dual-Loop Injection-Locked PLL with −243db FOM Using Synthesizable All-Digital PVT Calibration Circuits

Enhanced Digital Synthesized Phase Locked Loop with High Frequency Compensation and Clock Generation

An improved Phase/Frequency Detector and a glitch-suppression charge pump design for PLL applications

25.6 A 70.5-to-85.5GHz 65nm phase-locked loop with passive scaling of loop filter