Improved Molecular Ordering in a Ternary Blend Enables All‐Polymer Solar Cells over 18% Efficiency
Yunhao Cai,Cong Xie,Qian Li,Chunhui Liu,Jiaxin Gao,Min Hun Jee,Jiawei Qiao,Yun Li,Jiali Song,Xiaotao Hao,Han Young Woo,Zheng Tang,Yinhua Zhou,Chunfeng Zhang,Hui Huang,Yanming Sun
DOI: https://doi.org/10.1002/adma.202208165
IF: 29.4
2022-12-05
Advanced Materials
Abstract:Although all‐polymer solar cells (all‐PSCs) show great commercialization prospects, their power conversion efficiencies (PCEs) still fall behind their small molecule acceptor‐based counterparts. In all‐polymer blends, the optimized morphology and high molecular ordering are difficult to achieve since there is trouble‐some competition between the crystallinity of the polymer donor and acceptor during the film‐formation process. Therefore, it is challenging to improve the photovoltaic performance of all‐PSCs. We herein adopt a ternary strategy to modulate the morphology and the molecular crystallinity of an all‐polymer blend, in which PM6:PY‐82 was selected as the host blend and PY‐DT was employed as a guest component. Benefiting from the favorable miscibility of the two acceptors and the higher regularity of PY‐DT, the ternary matrix features a well‐defined fibrillar morphology and improved molecular ordering. As a result, the champion PM6:PY‐82:PY‐DT device produces a record‐high PCE of 18.03%, with simultaneously improved open‐circuit voltage, short‐circuit current and fill factor in comparison with the binary devices. High‐performance large‐area (1 cm2) and thick‐film (300 nm) all‐PSCs were also successfully fabricated with PCEs of 16.35% and 15.70%, respectively. More importantly, 16.5 cm2 organic solar module affords an encouraging PCE of 13.84% when using the non‐halogenated solvent (o‐xylene), showing the great potential of "Lab‐to‐Fab" transition of all‐PSCs. This article is protected by copyright. All rights reserved
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology