Abstract:Hydrogen storage in metal hydrides is a promising alternative to common storage methods. The surface of a metal hydride plays an important part in the absorption of hydrogen, since important partial reaction steps take place here. The development of surface contaminations and their influence on hydrogen absorption is examined by means of absorption experiments and surface analysis, using X-ray photoelectron spectroscopy (XPS), thermal desorption mass spectrometry (TDMS) and secondary neutral mass spectrometry (SNMS), in this work. All investigations were carried out on a modern AB(2) metal hydride alloy, namely Ti(0.96)Zr(0.04)Mn(1.43)V(0.45)Fe(0.08). Surface analysis (SNMS, XPS) shows that long-term air storage (several months) leads to oxide layers about 15 nm thick, with complete oxidation of all main alloy components. By means of in situ oxygen exposure at room temperature and XPS analysis, it can be shown that an oxygen dose of about 100 Langmuirs produces an oxide layer comparable to that after air storage. Manganese enrichment (segregation) is also clearly observed and is theoretically described here. This oxide layer hinders hydrogen absorption, so an activation procedure is necessary in order to use the full capacity of the metal hydride. This procedure consists of heating (T = 120 degrees C) in vacuum and hydrogen flushing at pressures like p = 18 bar. During the activation process the alloy is pulverized to particles of approximately 20 microm through lattice stretches. It is shown that this pulverization of the metal hydride (creating clean surface) during hydrogen flushing is essential for complete activation of the material. Re-activation of powder contaminated by small doses of air (p approximately 0.1 bar) does not lead to full absorption capacity. In ultrahigh vacuum, hydrogen is only taken up by the alloy after sputtering of the surface (which is done in order to remove oxide layers from it), thus creating adsorption sites for the hydrogen. This is shown by TDMS measurements with and without sputtering and oxygen exposure.

Atom Probe Analysis of Ex Situ Gas-Charged Stable Hydrides

Hydrogen and deuterium charging of lifted-out specimens for atom probe tomography

Hydrogen and deuterium charging of site-specific specimen for atom probe tomography

In Situ Pulsed Hydrogen Implantation in Atom Probe Tomography

Atom probe tomography of deuterium-charged optimised ZIRLO

Quantification challenges for atom probe tomography of hydrogen and deuterium in Zircaloy-4

Atomic Imaging of Subsurface Interstitial Hydrogen and Insights into Surface Reactivity of Palladium Hydrides

Miniaturized gas exposure devices for atom probe experiments

Initial report on molecular modeling of metal hydrides

A Gas-Phase Reaction Cell for Modern Atom Probe Systems

Resolving hydrogen atoms at metal-metal hydride interfaces

In-situ hydrogen charging of zirconium powder to study isothermal percipitation of hydrides and determination of Zr-hydride crystal structure

Characterizing solute hydrogen and hydrides in pure and alloyed titanium at the atomic scale

Influence of surface contaminations on the hydrogen storage behaviour of metal hydride alloys

First-principles investigation of rhodium hydrides under high pressure

Atomic-scale investigation of hydrogen distribution in a Ti-Mo alloy

Optimizing site-specific specimen preparation for Atom Probe Tomography by using hydrogen for visualizing radiation-induced damage

Ion Beam Measurement of Deuterium in Palladium and Calculation of Hydrogen Isotope Separation Factors

In Situ Time-Resolved Decomposition of β-Hydride Phase in Palladium Nanoparticles Coated with Metal-Organic Framework

Producing High Concentrations of Hydrogen in Palladium via Electrochemical Insertion from Aqueous and Solid Electrolytes

Towards Establishing Best Practice in the Analysis of Hydrogen and Deuterium by Atom Probe Tomography