Abstract:Atom Probe Tomography (APT) analysis is being actively used to provide near-atomic-scale information on the composition of complex materials in three-dimensions. In recent years, there has been a surge of interest in the technique to investigate the distribution of hydrogen in metals. However, the presence of hydrogen in the analysis of almost all specimens from nearly all material systems has caused numerous debates as to its origins and impact on the quantitativeness of the measurement. It is often perceived that most H arises from residual gas ionization, therefore affecting primarily materials with a relatively low evaporation field. In this work, we perform systematic investigations to identify the origin of H residuals in APT experiments by combining density-functional theory (DFT) calculations and APT measurements on an alkali and a noble metal, namely Na and Pt, respectively. We report that no H residual is found in Na metal samples, but in Pt, which has a higher evaporation field, a relatively high signal of H is detected. These results contradict the hypothesis of the H signal being due to direct ionization of residual H$_2$ without much interaction with the specimen's surface. Based on DFT, we demonstrate that alkali metals are thermodynamically less likely to be subject to H contamination under APT-operating conditions compared to transition or noble metals. These insights indicate that the detected H-signal is not only from ionization of residual gaseous H$_2$ alone, but is strongly influenced by material-specific physical properties. The origin of H residuals is elucidated by considering different conditions encountered during APT experiments, specifically, specimen-preparation, transportation, and APT-operating conditions by taking thermodynamic and kinetic aspects into account.

Quantification challenges for atom probe tomography of hydrogen and deuterium in Zircaloy-4

Towards Establishing Best Practice in the Analysis of Hydrogen and Deuterium by Atom Probe Tomography

Hydrogen and deuterium charging of site-specific specimen for atom probe tomography

Hydrogen and deuterium charging of lifted-out specimens for atom probe tomography

Deep Insight of Unique Phase Transition Behaviors and Mechanism in Zr 2 Co-H Isotope System with Ultra-Low Equilibrium Pressure

Nanoscale characterisation of hydrides and secondary phase particles in Zircaloy-4

High-throughput Computing for Hydrogen Transport Properties in Ε-Zrh2

Optimizing site-specific specimen preparation for Atom Probe Tomography by using hydrogen for visualizing radiation-induced damage

Atom Probe Analysis of Ex Situ Gas-Charged Stable Hydrides

Origins of the hydrogen signal in atom probe tomography

Solute hydrogen and deuterium observed at the near atomic scale in high-strength steel

Hydrogen Isotopic Replacement and Microstructure Evolution in Zirconium Deuteride Implanted by 150 Kev Protons

Atomic scale analysis of grain boundary deuteride growth front in Zircaloy-4

Atom probe tomography of deuterium-charged optimised ZIRLO

Resolving hydrogen atoms at metal-metal hydride interfaces

Towards Quantitative Analysis of Deuterium Absorption in Ferrite and Austenite during Electrochemical Charging by Comparing Cyclic Voltammetry and Cryogenic Transfer Atom Probe Tomography

Atomic-scale investigation of hydrogen distribution in a Ti-Mo alloy

Quantification of Solute Topology in Atom Probe Tomography Data: Application to the Microstructure of a Proton-Irradiated Alloy 625

Accurate measurement of hydrogen concentration in transition metal hydrides utilizing electronic excitations by MeV ions