Twist-tuned suppression of higher-order modes in single-ring hollow-core photonic crystal fibers

N. N. Edavalath,M. C. Günendi,R. Beravat,G. K. L. Wong,M. H. Frosz,J.-M. Ménard,P. ST.J. Russell
DOI: https://doi.org/10.48550/arXiv.1703.00872
2017-03-03
Abstract:Optimum suppression of higher order modes in single-ring hollow-core photonic crystal fibers (SR-PCFs) occurs when the capillary-to-core diameter ratio d/D = 0.68. Here we report that, in SR-PCFs with sub-optimal values of d/D, higher-order mode suppression can be recovered by spinning the preform during fiber drawing, thus introducing a continuous helical twist. This geometrically increases the effective axial propagation constant (initially too low) of the LP01-like modes of the capillaries surrounding the core, enabling robust single-mode operation. The effect is explored by means of extensive numerical modeling, an analytical model and a series of experiments. Prism-assisted side-coupling is used to investigate the losses and near-field patterns of individual fiber modes in both the straight and twisted cases. More than 12 dB/m improvement in higher order mode suppression is achieved experimentally in a twisted PCF. The measurements also show that the higher order mode profiles change with twist rate, as predicted by numerical simulations. Helical twisting offers an additional tool for achieving effectively endlessly single-mode operation in hollow-core SR-PCFs.
Optics
What problem does this paper attempt to address?
This paper attempts to solve the problem of insufficient suppression of higher - order modes (HOMs) in single - ring hollow - core photonic crystal fibers (SR - PCFs). Specifically: 1. **Background problems**: - SR - PCFs are a type of anti - resonant reflection (ARR) - type hollow - core photonic crystal fiber with a relatively simple structure, having low transmission loss and a wide wavelength range. - However, such fibers usually support multiple higher - order modes, and the losses of these modes are similar to those of the fundamental mode, making it difficult to achieve pure fundamental - mode transmission, which poses a challenge for many applications. 2. **Existing solutions and their limitations**: - Previous research has shown that when the ratio of capillary diameter to core diameter \(\frac{d}{D} = 0.68\), the higher - order modes can be optimally suppressed. - However, the manufacturing tolerance to meet this condition is very strict, and in the actual preparation process, the capillary diameter is often too small to meet the requirement of \(\frac{d}{D}=0.68\). 3. **Proposed new method**: - This paper proposes a method to restore the suppression of higher - order modes by introducing a helical twist. Rotate the preform during the fiber drawing process, thereby introducing a continuous helical twist. - This geometric twist increases the effective axial propagation constant of the capillary mode (which was initially too low), enabling the LP01 - like capillary mode to be phase - matched with the core mode, thereby achieving robust single - mode operation. 4. **Experimental verification**: - The effectiveness of this method has been verified through numerical simulation, theoretical analysis, and a series of experiments. - The experimental results show that in the twisted PCF, the suppression of higher - order modes has been improved by more than 12 dB/m. - The measurement results also indicate that as the twist rate changes, the distribution of higher - order modes also changes, which is consistent with the prediction of numerical simulation. 5. **Conclusion**: - The helical twist provides an additional tool to achieve effective single - mode transmission when the d/D ratio is not ideal, especially in the 1064 - nm wavelength range, where the figure of merit (FOM) for suppressing higher - order modes exceeds 1000 with a bandwidth of 43 nm. Therefore, the main contribution of this paper is to propose and verify a new method for effectively suppressing higher - order modes through helical twist, solving a key problem in the practical application of SR - PCFs.